LPScreen
LPScreen NE140WUM-N6G 14" WUXGA 1920x1200 60Hz laptop screen
A 14 inch WUXGA 1920x1200 60Hz laptop replacement screen with 400 cd/m² brightness, 1500:1 contrast, 99% sRGB colour and a 30 pin connector
- Compatible ModelsNE140WUM-N6G
- Screen Size14"
- Screen ResolutionWUXGA 1920x1200
- Sharp detail from 1920x1200 WUXGA resolution
- 7M colours covering 99% sRGB for accurate tones
- 400 cd/m² brightness suits bright rooms
- Wide 89° viewing angles stay clear off-centre
- 30-pin connector fits NE140WUM-N6G models
Screen compatibility and fit
This replacement screen is built for the NE140WUM-N6G model and matches the original 14 inch WUXGA 1920x1200 specification at 60Hz. It uses a 30 pin connector and delivers 400 cd/m² brightness with a 1500:1 contrast ratio. Viewing angles reach 89 degrees in all directions for consistent colour.
Who this suits and who it does not
The panel suits repairers restoring a 14 inch non touch laptop to its factory 16.7M 99% sRGB panel. It will not work for systems that require a touch digitiser, a different pin count, or a higher refresh rate. Buyers needing a touchscreen or a different resolution should look elsewhere.
Deciding specification: 30 pin connector
The 30 pin connector is the single detail that decides fitment. Even when size and resolution match, a different pin layout will prevent installation. Verify the original screen uses a 30 pin interface before ordering to ensure compatibility.
Highlights
- Sharp detail from 1920x1200 WUXGA resolution
- 7M colours covering 99% sRGB for accurate tones
- 400 cd/m² brightness suits bright rooms
- Wide 89° viewing angles stay clear off-centre
- 30-pin connector fits NE140WUM-N6G models
Specifications
| Model | NE140WUM-N6G |
|---|---|
| Part Number | NE140WUM-N6G |
| Compatible Models | NE140WUM-N6G |
| Screen Size | 14" |
| Screen Resolution | WUXGA 1920x1200 |
Questions about this item
Will my laptop need a 30-pin eDP cable to connect this NE140WUM-N6G panel?
Yes, the screen uses a 30-pin connector, so the host device must provide a matching 30-pin eDP interface for the display to operate.
Can I keep my existing 60 Hz non-touch 14-inch panel and swap only the display module?
The replacement is a 14-inch 1920×1200 60 Hz non-touch panel with 400 cd/m² brightness and 1500:1 contrast, so it matches the same electrical and mechanical profile.
How can I verify the screen is delivering 99 % sRGB colour after installation?
Run a calibration tool or OS colour-profile check; the panel specification lists 16.7 million colours covering 99 % sRGB, so a correct profile will show that gamut.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



