LPScreen
LPScreen N160JME-GEK 16 inch WUXGA 1920x1200 165Hz laptop screen
A 16 inch WUXGA 1920x1200 laptop replacement panel with 165Hz refresh, 300 cd/m² brightness, 1200:1 contrast, 16.7M 45% NTSC colour and a 40 pin connector
- Compatible ModelsN160JME-GEKREV.C1
- Screen Size16”
- Screen ResolutionWUXGA 1920x1200
- 16-inch WUXGA 1920x1200 resolution for sharp detail
- 165Hz refresh rate delivers smooth motion
- 300 cd/m² brightness ensures clear visibility
- 1200:1 contrast ratio produces deep blacks
- 40-pin connector matches N160JME-GEK REV.C1 exactly
16 inch WUXGA 165Hz panel
This 16 inch laptop display delivers a WUXGA 1920x1200 resolution at a 165Hz refresh rate. It uses a 40 pin connector and a non-touch surface. The panel is built as a direct replacement for the N160JME-GEK REV.C1 model. Brightness reaches 300 cd/m² with a 1200:1 contrast ratio.
Best for high refresh laptop repair
The screen suits owners of a compatible 16 inch chassis who need a 165Hz panel with 45% NTSC colour coverage. Wide 89 degree viewing angles support consistent colour from multiple positions. Buyers who require touch input or a wider colour gamut should look at a different part.
Verify REV.C1 and 40 pin match
The single specification that decides fit is the exact REV.C1 revision combined with the 40 pin interface. Matching the model number alone is not sufficient; the revision and pin count must align with the original panel. Email requirements after ordering if confirmation is needed.
Highlights
- 16-inch WUXGA 1920x1200 resolution for sharp detail
- 165Hz refresh rate delivers smooth motion
- 300 cd/m² brightness ensures clear visibility
- 1200:1 contrast ratio produces deep blacks
- 40-pin connector matches N160JME-GEK REV.C1 exactly
Specifications
| Model | N160JME-GEKREV.C1 |
|---|---|
| Part Number | N160JME-GEKREV.C1 |
| Compatible Models | N160JME-GEKREV.C1 |
| Screen Size | 16” |
| Screen Resolution | WUXGA 1920x1200 |
Questions about this item
What does the 40-pin connector on the N160JME-GEK REV.C1 support?
The 40-pin connector carries the WUXGA 1920x1200 signal at 165Hz; it is the only video and power interface on this panel.
What bezel and chassis clearance does the 16-inch panel need?
The active area fits a standard 16-inch frame; the 40-pin flex exits from the lower edge, so the hinge cut-out must align with that cable route.
How is the N160JME-GEK REV.C1 installed and which step causes the most issues?
Remove the bezel, disconnect the old 40-pin cable, connect the new cable ensuring the latch clicks, then test before refitting the bezel; the latch not seating fully is the common error.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



