We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Yellow XT60 male plug to silver DC 7.4x5.0mm male jack adapter cable

LORDWORLD

LORDWORLD XT60 Male SC100 to DC 7.4x5.0mm Male Adapter

SKU CH-4WF1-27PFM

XT60 male to DC 7.4×5.0 mm male adapter with SC100 fast-charging protocol for powering TS100 soldering irons, drones and RC gear from XT60 batteries

  • XT60 male connector plugs straight into RC LiPo batteries for quick field power
  • DC 7.4 × 5.0 mm male tip fits TS100 soldering irons without extra cables
  • SC100 protocol support enables fast charging from compatible battery packs
  • High-temperature resistant materials and solid insulation keep connections safe under load
  • Plug-and-play design works with drones, FPV gear, solar setups and RC toys

Field-Ready Power Link

This LORDWORLD adapter bridges an XT60 male connector to a DC 7.4x5.0mm male plug, letting pilots and hobbyists run a TS100 soldering iron or charge RC lipos directly from a flight pack. It targets field technicians, FPV builders and aeromodelling enthusiasts who need a compact, plug-and-play cable without soldering their own leads. The SC100 protocol support enables fast-charging negotiation where the battery and device both implement it.

Sustained Current Handling

High-temperature-resistant insulation and quality contact materials keep resistance low during long soldering sessions or repeated quadcopter battery swaps. The 60-rated XT60 side and 100-rated protocol handshake are designed for continuous load rather than brief peaks, so voltage drop stays predictable when the iron holds temperature or a multicopter draws heavy amps. No active cooling is present, so free airflow around the moulded body is assumed.

Straightforward Installation

Plug the XT60 end into the battery and the DC barrel into the TS100 or compatible device; no tools or firmware steps are required. Polarity follows the standard XT60 and 7.4x5.0mm conventions, but users must verify their specific battery and iron wiring before first use. The moulded strain relief resists cable fatigue, yet the rigid barrel can stress a jack if the iron is left hanging unsupported.

Highlights

  • XT60 male connector plugs straight into RC LiPo batteries for quick field power
  • DC 7.4 × 5.0 mm male tip fits TS100 soldering irons without extra cables
  • SC100 protocol support enables fast charging from compatible battery packs
  • High-temperature resistant materials and solid insulation keep connections safe under load
  • Plug-and-play design works with drones, FPV gear, solar setups and RC toys

Specifications

BrandLORDWORLD

Questions about this item

Does the XT60 male connector on this adapter get hot when powering a TS100 soldering iron for long sessions?

The adapter uses high-temperature-resistant materials and good insulation to handle the sustained current a TS100 iron draws from an XT60 battery.

What must I already own to use this adapter with a TS100 soldering iron?

You need a TS100 soldering iron and a battery or power source that provides an XT60 output port.

Will this DC 7.4x5.0mm plug fit the power input on my existing TS100 soldering iron?

Yes, the DC 7.4x5.0mm male connector matches the TS100's power input for direct plug-and-play use.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.