LORDWORLD Xiwai XT60 Power Connector Male SC100 Protocol to DC 5.5x2.5mm Male Plug Fast Charging Adapter

XT60-to-DC adapter for TS100 soldering iron

This adapter bridges an XT60 male connector to a DC 5.5 x 2.5 mm male plug using the SC100 protocol. It is built for hobbyists who power a TS100 soldering iron from an RC LiPo battery during field repairs. The moulded housing uses high-temperature-resistant insulation for safe, plug-and-play operation. Pilots flying FPV multirotors will find it a compact addition to a flight bag.

Check battery connector

Verify that your power source provides an XT60 female port and that the soldering iron accepts a 5.5 mm barrel jack with 2.5 mm centre pin. The adapter follows the SC100 handshake, so the iron must support that protocol to negotiate fast charging. No voltage conversion is performed; the battery voltage passes straight through. Ensure your LiPo cell count matches the iron’s operating range.

SC100 handshake enables negotiated fast charging

The built-in SC100 controller lets the TS100 request higher current from compatible LiPo packs instead of defaulting to a lower rate. This reduces heat-up time when repairing drones, quadcopters or other RC gear at the field. The rugged XT60 shell resists vibration and accidental disconnects during transport. No extra cables or software are included in the package.