We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
A short Y-splitter cable with a 19/20-pin male connector branching to two USB 3.0 female ports

LORDWORLD

LORDWORLD USB 3.0 19/20-Pin Male to 2 Female Y Splitter 20cm

SKU CH-82MP-0MN0V

Splits one motherboard 19/20-pin header into two USB 3.0 Type-A ports with a 20 cm cable

  • Splits one 19/20-pin header into two USB 3.0 Type-A ports
  • Connects front-panel USB 3.0 devices directly to the motherboard header
  • 20 cm cable keeps internal routing tidy
  • Supports USB 3.0 speeds up to 5 Gbps
  • Compatible with 20-pin headers such as Asus P7P55/USB3

Front-panel USB 3.0 splitter for desktop builds

This adapter converts a single motherboard 19/20-pin USB 3.0 header into two standard type-A female ports. It is designed for PC builders who need extra front-panel connectivity without adding a controller card. The 20 cm cable keeps routing tidy inside compact cases.

Connects directly to a 20-pin header

Plug the male header into the board's internal USB 3.0 connector, then attach two front-panel cables or devices to the female ends. No additional drivers or external power are required. The short length reduces clutter and leaves rear ports available for other peripherals.

Maintains USB 3.0 speeds under continuous transfers

The passive wiring preserves the 5 Gb/s signalling rate during sustained file copies or device streaming. Signal integrity depends on the motherboard header quality and cable shielding. Builders needing more than two ports or longer runs should consider an active hub instead.

Highlights

  • Splits one 19/20-pin header into two USB 3.0 Type-A ports
  • Connects front-panel USB 3.0 devices directly to the motherboard header
  • 20 cm cable keeps internal routing tidy
  • Supports USB 3.0 speeds up to 5 Gbps
  • Compatible with 20-pin headers such as Asus P7P55/USB3

Specifications

BrandLORDWORLD

Questions about this item

Will the single 20-pin header on my motherboard supply enough bandwidth for both USB 3.0 ports at once?

The splitter shares one 20-pin header between two USB 3.0 type-A ports, so total throughput is limited to the header's single USB 3.0 channel.

Does the 20 cm cable add noticeable resistance or heat when both ports run all day?

At 20 cm the cable is very short, so voltage drop and heat build-up are minimal even with continuous use.

My case front panel only has USB 3.0 type-A cables — do I need any extra adapters?

No, the splitter provides two USB 3.0 type-A female ports ready for your existing front-panel cables.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.