LORDWORLD SATA III 3.0 22Pin Male-Female 90° UP Angled Extension Cable 30cm

SATA III 22-pin extension for tight builds

This 30 cm cable adds a 90° upward-angled male-to-female connection so you can route power and data to a drive when the motherboard or backplane port is hemmed in by other components. It carries both 5 V and 12 V lines plus ground on five conductors, letting 2.5" and 3.5" SATA disks receive full power without a separate adapter. The SATA III rating supports 6 Gbps transfer speeds for modern SSDs and hard drives. Builders working in compact cases or dense drive cages gain the extra reach they need without redesigning cable runs.

Capacity and headroom: 6 Gbps data

The cable passes the full SATA III 6 Gbps signal, so sequential reads and writes on current SSDs are not bottlenecked by the extension. It delivers 5 V and 12 V simultaneously, meaning a single 3.5" mechanical drive or a power-hungry 2.5" SSD gets both rails without voltage drop over the short 30 cm run. Headroom ends where the angled connector cannot clear a neighbouring header or where a longer reach is required; the fixed 30 cm length and upward bend direction cannot be altered, so measure your routing path before ordering.

Build quality and daily implications

The moulded 22-pin plugs lock securely into drive and board ports, reducing accidental disconnects during transport or vibration. The right-angle upward orientation keeps the cable hugging the PCB or drive chassis, improving airflow and preventing the connector from fouling side-panel windows or adjacent cards. Because the bend direction is fixed, the cable only suits ports that have clearance above them; ports with overhead obstructions will need a different angle or a straight-through extender.