LORDWORLD
LORDWORLD PCI-E 5.0 MCIO Angled Slimline SAS 8i 74Pin Male to MCIO 74Pin Male Extender Cable 35cm
Angled MCIO 74-pin extender cable supports PCIe 5.0 and SAS at 24 Gbps over 35 cm
- Fast 24 Gbps transfers for demanding data-centre workloads
- Angled MCIO 74-pin male connector eases tight chassis routing
- PCI-E 5.0 ready for next-generation bandwidth headroom
- Slimline SAS 8i interface fits high-density backplanes
- 35 cm length balances reach with signal integrity
Data-center interconnect cable
The LORDWORLD MCIO extender connects a PCI-E 5.0 Slimline SAS 8i 74-pin male port to another MCIO 74-pin male port. It is built for data-centre, networking and telecom equipment that relies on SAS, PCIe or Ethernet signalling through SFF-8654 connectors.
Straightforward plug-in fitting
Installation is a simple matter of inserting each 74-pin end into the matching receptacle on the host device and the target drive or backplane. The angled Slimline SAS connector eases routing in dense chassis, but the cable only works where both ends present a compatible MCIO 74-pin interface.
24 Gbps channel with 35 cm reach
The assembly supports high-speed transfers up to 24 Gbps across its 35 cm length, giving enough slack for adjacent board-to-board or cable-to-board links. It cannot bridge longer distances or serve devices that lack an MCIO 74-pin SFF-8654 connection.
Highlights
- Fast 24 Gbps transfers for demanding data-centre workloads
- Angled MCIO 74-pin male connector eases tight chassis routing
- PCI-E 5.0 ready for next-generation bandwidth headroom
- Slimline SAS 8i interface fits high-density backplanes
- 35 cm length balances reach with signal integrity
Specifications
| Brand | LORDWORLD |
|---|
Questions about this item
How can I verify the 24 Gbps link is active after connecting the MCIO 74-pin ends?
Check the host controller or drive firmware for a negotiated PCIe 5.0 x4 or SAS-4 24 Gbps link speed and run a sequential read test to confirm sustained throughput.
What ships with the cable and what must I source separately?
Only the 35 cm MCIO 74-pin male to MCIO 74-pin male extender is included; matching SFF-8654 SSDs, backplanes or controller cards are not supplied.
Which version should I choose for a PCIe 5.0 SSD using the SFF-8654 connector?
This single 35 cm, 74-pin MCIO extender is built for PCIe 5.0 and SAS 24 Gbps, so it fits any SFF-8654 drive or backplane without further selection.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



