LORDWORLD
LORDWORLD 60x60x25mm DC12V 0.60A 4-Hole 3-Wire Chassis Power Supply Cooling Fan
A 60 mm square, 25 mm thick chassis cooling fan running on 12 V DC at 0.60 A with a three-wire connection and four mounting holes
- Fits standard 60 mm fan mounts with 4-hole pattern
- 12 V DC input draws only .60 A for low power use
- 3-wire connection enables speed monitoring and control
- 25 mm thickness suits tight chassis and power supply spaces
60×60×25 mm DC 12 V chassis cooling fan
This LORDWORLD fan measures 60 by 60 by 25 millimetres and runs on 12 volts DC at 0.60 amperes. It uses a three-wire connection and mounts with four screw holes. The unit is intended for chassis or power-supply airflow in electronic enclosures.
Check voltage, connector
Verify that your power supply or chassis provides a 12 V DC source rated for at least 0.60 A. Confirm the three-wire pinout matches the header on your board or controller. Ensure the four-hole pattern aligns with the existing mounting points in your case.
Highlights
- Fits standard 60 mm fan mounts with 4-hole pattern
- 12 V DC input draws only .60 A for low power use
- 3-wire connection enables speed monitoring and control
- 25 mm thickness suits tight chassis and power supply spaces
Specifications
| Brand | LORDWORLD |
|---|
Questions about this item
Does the 60x60x25mm fan include mounting screws or do I need to buy them separately?
The unit is supplied as the fan only; four mounting screws must be purchased separately to use the 4-hole pattern.
Is the 0.60A 12V version the only option or are other current ratings available?
This listing is for the 0.60A 12V model; other current ratings are not offered under this part number.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



