LORDWORLD
LORDWORLD 30A 125/250V Nema L14-30P Inlet Box AD0069
A weatherproof 30 amp NEMA L14-30P inlet box rated for 7500 watts with ETL listing and a green indicator light
- Outdoor-ready power inlet with ETL-listed safety
- 30-amp 125/250-volt rating supports up to 7500-watt loads
- Weatherproof steel enclosure protects connections in harsh conditions
- Green indicator light confirms active power at a glance
- Mounts securely with three pre-drilled holes for copper wire installation
Outdoor generator inlet box
This NEMA L14-30P inlet box connects a portable generator to a building electrical system. It is rated for 30 amps at 125/250 volts with a maximum capacity of 7500 watts. The steel enclosure carries an ETL listing for outdoor installation only.
Weatherproof steel enclosure with indicator
The powder-coated steel cabinet mounts on an exterior wall using three pre-drilled holes in the back. A green light indicator shows when power is present at the inlet. The weatherproof design protects the internal terminals from rain and debris during outdoor use.
Copper wiring requirement
Terminals accept copper conductors only and the manufacturer suggests 10 AWG wire for the installation. The colour scheme assigns black and red to the 250 volt load terminals, white to the neutral terminal marked W, and green to the ground screw inside the cabinet. Builders who need aluminium-wire compatibility cannot use this inlet box.
Highlights
- Outdoor-ready power inlet with ETL-listed safety
- 30-amp 125/250-volt rating supports up to 7500-watt loads
- Weatherproof steel enclosure protects connections in harsh conditions
- Green indicator light confirms active power at a glance
- Mounts securely with three pre-drilled holes for copper wire installation
Specifications
| Brand | LORDWORLD |
|---|
Questions about this item
How do I mount the LORDWORLD AD0069 inlet box and which wire gauge is required?
Mount the steel cabinet outdoors using the three holes on the back. The terminals accept only copper conductors; the manufacturer specifies 10AWG copper wire for the 30A 125/250V connection.
What ongoing maintenance does the AD0069 inlet box need after installation?
Inspect the weatherproof seal and the green indicator light periodically. Tighten the X, Y, white (W) and green ground terminals if they loosen, and replace any corroded copper conductors to maintain the 30A rating.
What is the first limit reached when the AD0069 runs at full load for an extended period?
The unit is rated for a maximum of 7500 watts at 30A 125/250V. Sustained operation above that wattage will exceed the ETL-listed thermal and current limits of the inlet.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



