Logisys Computer Inc.
Logisys Computer Inc. Power Supply for Compaq Presario SR1100 Series SR1102B
Replacement power supply for Compaq Presario SR1100 series desktops, tested to CSA 22.2 Level 3 with CB, CE, FCC and cUL approvals
- CSA 22.2 Level 3 certified for safety compliance
- 100% hi-pot and function tested on every unit
- Burn-in under high ambient temperature ensures reliability
- Approved by CB, CE, CSA, FCC, cUL, TUV
- MTBF exceeds 100,000 hours for long service life
Compaq SR1100 replacement supply
This Logisys Computer Inc. unit is a direct replacement power supply built for Compaq Presario SR1100 series desktops, including the SR1102B model. It carries CB, CE, CSA, FCC, cUL and TUV approvals and meets CSA 22.2 Level 3 requirements with 100 per cent hi-pot and functional testing.
Builders who need higher wattage or modular cables
The supply is intended for owners restoring or repairing an original SR1100 chassis where the factory form factor and connector layout must match. It is not for systems requiring a different physical size, alternate connector arrangement, or greater output capacity than the original design provides.
Tested to over 100 000 hours MTBF
A mean time between failures exceeding 100 000 hours is the key reliability figure that distinguishes this unit. The burn-in at high ambient temperature and full hi-pot verification support that rating for long-term service in the target desktop.
Highlights
- CSA 22.2 Level 3 certified for safety compliance
- 100% hi-pot and function tested on every unit
- Burn-in under high ambient temperature ensures reliability
- Approved by CB, CE, CSA, FCC, cUL, TUV
- MTBF exceeds 100,000 hours for long service life
Specifications
| Brand | Compaq |
|---|
Questions about this item
Will this power supply fit the Compaq Presario SR1102B desktop case?
The unit is built as a direct upgrade for the Compaq Presario SR1100 series and is confirmed to fit the SR1102B model.
What is the correct way to connect the 115Vac input during installation?
Verify the voltage selector is set to 115Vac before plugging the IEC power cord into a grounded outlet; the supply is tested at 100% hi-pot and burn-in for this operation.
How long is the power supply rated to run before a replacement is likely needed?
The manufacturer specifies an MTBF greater than 100,000 hours under high ambient temperature burn-in conditions.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Taylor Made 12" x 18" Jolly Roger Novelty Flag 1818 marine electronic
- Accessories



