Loc-Line
Loc-Line Round Nozzle 0.062" Hole PK2 HAWA 41424
Two-piece round nozzle with 0.062 in hole, 1.25 in reach and 170-degree swing for machining coolant lines
- MaterialHAWA
- Precise flow control with 0.062 in hole diameter
- Wide positioning range from 170 degree swing angle
- Extended reach of 1.25 in for tight spaces
- Durable acetal and stainless steel construction
- Two nozzles included for immediate use
Precision Coolant Nozzle
The Loc-Line Round Nozzle 41424 delivers a focused 0.062-inch coolant stream for machining operations. Its acetal and stainless steel construction handles 110 psi maximum pressure while the 170-degree swing allows flexible positioning. Packaged in pairs, it suits CNC operators needing reliable, adjustable fluid delivery at the cutting zone.
Replaces Fixed Orifice Tips
Swap out rigid, single-angle nozzles when workpiece geometry demands variable coolant angles without repositioning the entire hose assembly. The 1.25-inch reach extends access into confined fixture areas where standard tips cannot reach. The upgrade is worthwhile when frequent manual readjustment slows cycle times or when chip clearance requires precise, redirected flow.
Integrates With Modular Hose Systems
Thread the 1/4-inch NPT fitting directly onto compatible Loc-Line segmented hose for tool-free reconfiguration. The acetal body resists common cutting fluids while stainless internals maintain orifice integrity over extended use. It frees operators from hard-plumbed coolant lines, enabling rapid nozzle changes between jobs without tools or thread sealant.
Highlights
- Precise flow control with 0.062 in hole diameter
- Wide positioning range from 170 degree swing angle
- Extended reach of 1.25 in for tight spaces
- Durable acetal and stainless steel construction
- Two nozzles included for immediate use
Specifications
| Brand | Loc-Line |
|---|---|
| Material | HAWA |
Questions about this item
Will the 1/4-inch NPT thread fit my existing coolant hose?
The nozzle has a 1/4-inch NPT thread and a 1/4-inch hose inside diameter, matching standard fittings for direct connection.
How far does the nozzle extend once threaded into the port?
The reach is 1.25 inches from the thread base, and the joint swings 170 degrees for positioning.
When should I replace the nozzle due to wear?
Replace if the 0.062-inch hole erodes, the acetal body cracks, or the stainless components corrode beyond the 110 psi pressure rating.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
