Loc-Line
Loc-Line 60532 Fixed Mount with Magnetic Base fluid
A fixed magnetic-base mount for 3/4-inch Loc-Line hose systems, rated for 10 to 20 PSI and resistant to oils, solvents and detergents
- Magnetic base secures fixture without drilling
- Fixed mount holds 3/4 in hose firmly in place
- Acetal copolymer resists gasoline, oils and common solvents
- Rated for 10-20 PSI operating pressure
- California Proposition 65 chemical warning applies
Fixed Mount with Magnetic Base
This Loc-Line 60532 fixed mount includes a magnetic base for secure attachment to ferrous surfaces. It is designed for use with 3/4 inch inside diameter flex hose systems. The mount suits machine shop operators needing a stable, repositionable coolant or lubricant delivery point. It is made from acetal copolymer material.
Pressure and chemical limits
The mount operates within a maximum pressure range of 10 to 20 PSI. Acetal copolymer construction resists acetone, ethyl alcohol, commercial dish detergents, gasoline, grease, lacquer solvents, oils and sodium hydroxide. Exposure to chemicals outside this listed group may degrade the material. California Proposition 65 warnings apply for cancer and reproductive harm.
Compatibility check
Verify that your existing flex hose system uses a 3/4 inch inside diameter before ordering. Confirm the mounting surface is ferrous to engage the magnetic base effectively. Ensure system pressure stays within the 10 to 20 PSI range during operation. Check that coolant or lubricant types match the listed chemical resistances.
Highlights
- Magnetic base secures fixture without drilling
- Fixed mount holds 3/4 in hose firmly in place
- Acetal copolymer resists gasoline, oils and common solvents
- Rated for 10-20 PSI operating pressure
- California Proposition 65 chemical warning applies
Specifications
| Brand | LOC-LINE |
|---|
Questions about this item
Should I pick the 60532 fixed mount or another version for my 3/4 in hose system?
The 60532 model is built specifically for 3/4 in inside-diameter Loc-Line flex hose, so it matches that size without adapters.
What does the 10-20 PSI pressure rating mean when the mount is installed on a machine?
It indicates the mount and magnetic base will hold securely and seal properly while coolant flows at typical low-pressure shop supply levels.
How does the magnetic base interface with a ferrous work surface, and what load does it handle?
The base clamps directly to any flat ferrous table or fixture, holding the 3/4 in hose assembly firmly under the rated 10-20 PSI coolant pressure.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
