Lincoln Electric
Lincoln Electric K530-5 MIG gun 100 A 10 ft straight handle 45° neck
A 10 ft air-cooled MIG gun rated for 100 A at 40 percent duty cycle with a fixed 45 degree neck and .035 in maximum wire diameter
- TypeWelding Parts & Supplies
- 100 A capacity handles light fabrication tasks
- 40 % duty cycle supports intermittent welding runs
- 10 ft cable gives reach around the workpiece
- 45° fixed neck improves torch positioning
- Straight handle design suits operator preference
100 A air-cooled MIG gun
This Lincoln Electric Magnum 100L gun handles MIG and flux-cored welding at up to 100 amps. It uses a 40 percent duty cycle with CO2 shielding gas and accepts solid or flux-cored wire up to .035 in diameter. The 10 ft cable connects to Lincoln-style rear fittings for direct machine compatibility.
Straight handle with 45° fixed neck
The straight grip and 45-degree neck suit operators who prefer a fixed-angle torch for bench or light fabrication work. Welders needing water cooling, higher amperage, a rotatable neck or a curved handle should consider other models.
Lincoln rear connection
The gun terminates in a Lincoln-specific rear connector, so it fits compatible Lincoln power sources without adapters. Buyers with Miller, Tweco or Euro-style feeders will need a different gun or a separate adapter kit.
Highlights
- 100 A capacity handles light fabrication tasks
- 40 % duty cycle supports intermittent welding runs
- 10 ft cable gives reach around the workpiece
- 45° fixed neck improves torch positioning
- Straight handle design suits operator preference
Specifications
| Brand | LINCOLN ELECTRIC |
|---|---|
| Type | Welding Parts & Supplies |
Questions about this item
How often will the Magnum 100A contact tips need replacing on this gun?
Tip life depends on wire quality and amperage used; the gun accepts Magnum 100A series tips which are widely available and simple to swap without tools.
At 100 A output how long can I weld continuously before the 40 % duty cycle forces a pause?
At the rated 100 A the gun runs for four minutes out of every ten; exceeding that amperage shortens the on-time further.
Does the air-cooled cable get too hot to hold during all-day production welding?
The air-cooled design relies on ambient airflow; at the 40 % duty cycle the handle stays comfortable, but sustained high-amperage runs will warm the cable noticeably.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
