We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black push-fit elbow fitting with 4mm tube end and threaded male end

Legris

Legris 3199 04 10 Male Elbow 4mm OD 290 PSI trap

SKU CH-3JCX-5755Y MPN 3199

Connects 4 mm tubing to a 1/8 in MBSPP port at up to 290 psi and 175 °F

  • TypeDrain Components
  • Push-to-connect 4 mm tube for quick installation
  • Male BSPP 1/8 in thread seals without extra sealant
  • Fiberglass-reinforced nylon body resists corrosion and vibration
  • Rated to 290 psi for reliable pneumatic service
  • Operates up to 175 °F in demanding environments

Push-Fit Elbow for 4 mm Tube

This Legris 3199 04 10 male elbow connects 4 mm outer-diameter tubing to a 1/8 inch MBSPP thread using a push-to-connect design. The fitting body is made from black fiberglass-reinforced nylon and is rated for a maximum operating pressure of 290 psi and a maximum operating temperature of 175 degrees Fahrenheit. It is supplied new in a pack of ten pieces.

Suits Pneumatic and Vacuum Lines

The elbow is intended for vacuum applications and low-pressure pneumatic circuits that use 4 mm push-fit tubing and require a compact 90-degree turn onto a male thread. It will not suit systems that demand metal-bodied fittings, higher pressure ratings, larger tube diameters, or different thread standards such as NPT or metric parallel threads.

290 psi Pressure Rating Decides Fit

The single specification that determines suitability is the 290 psi maximum operating pressure combined with the 4 mm tube size and 1/8 inch MBSPP thread. Verify that your system pressure stays below this limit and that the thread and tube dimensions match exactly before installation.

Highlights

  • Push-to-connect 4 mm tube for quick installation
  • Male BSPP 1/8 in thread seals without extra sealant
  • Fiberglass-reinforced nylon body resists corrosion and vibration
  • Rated to 290 psi for reliable pneumatic service
  • Operates up to 175 °F in demanding environments

Specifications

TypeDrain Components
BrandLegris
Model3199 04 10

Questions about this item

How much heat can the Legris 3199 04 10 elbow handle during continuous operation?

The fitting is rated for a maximum operating temperature of 175 Degrees F, so it will withstand typical compressed-air or vacuum line heat in continuous use.

What tube size and thread do I need on hand to install this push-fit elbow?

You need 4 mm outer-diameter tubing for the push-to-connect side and a female 1/8 in BSPP port for the male-threaded side.

Will the 290 psi rating of this elbow work with my older low-pressure pneumatic fittings?

Yes, the 290 psi maximum operating pressure exceeds typical low-pressure system requirements, so it is compatible with older components rated at lower pressures.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.