We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Brass push-fit trap 12mm OD to 1/2 NPT pack of ten

Legris

Legris 3175 12 22 Push-Fit Trap 12mm OD x 1/2 NPT PK10

SKU CH-F2A5-P3EH0 MPN 3175

Push-fit brass trap connects 12 mm tube to 1/2 NPT thread, rated 290 psi at 175 °F, pack of ten

  • TypeDrain Components
  • MaterialHAWA
  • Push-to-connect design speeds installation with 12 mm tube
  • Male NPT thread seals directly into 1/2 inch ports
  • Brass C36000 body handles 290 psi at 175 °F
  • Pre-applied thread sealant cuts assembly time per joint
  • Pack of 10 fittings covers multiple connection points

Push-Fit Drain Fitting

This push-fit drain fitting connects 12 mm outer-diameter tubing to a 1/2 NPT male thread. It is made from C36000 brass and includes pre-applied thread sealant for faster installation. The fitting suits vacuum applications and is supplied in a pack of ten units.

Suits Direct Vacuum Connections

Installers who need a quick, tool-free seal on 12 mm tube will find this fitting convenient. It is not intended for builders who require a different tube diameter, a female thread, or a fitting rated beyond 290 psi at 175 °F. Buyers needing other configurations should select an alternative part.

12 mm Push-to-Connect by 1/2 NPT

The critical specification is the combination of a 12 mm push-to-connect end and a 1/2 NPT male thread. This exact interface match determines whether the fitting integrates with the existing plumbing layout. Verify both connection types before ordering.

Highlights

  • Push-to-connect design speeds installation with 12 mm tube
  • Male NPT thread seals directly into 1/2 inch ports
  • Brass C36000 body handles 290 psi at 175 °F
  • Pre-applied thread sealant cuts assembly time per joint
  • Pack of 10 fittings covers multiple connection points

Specifications

TypeDrain Components
MaterialHAWA
BrandLegris
Model3175 12 22

Questions about this item

How do I install the 12 mm push-fit side and the 1/2 NPT thread without leaks?

Push the 12 mm tube firmly into the fitting until it seats; thread the 1/2 NPT end into the port using the pre-applied sealant — do not add tape or paste, which can prevent a proper seal.

What maintenance will the brass body and pre-applied sealant need over time?

Inspect the connection periodically for seepage; if the sealant dries out or the joint is disturbed, remove old sealant and apply fresh thread sealant before re-assembly.

At what temperature does the 290 psi pressure rating become unsafe during continuous operation?

The 290 psi maximum operating pressure is rated up to 175 °F; sustained use above that temperature reduces the safe pressure limit.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.