We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Nickel plated brass male connector push fit fitting pack of ten

Legris

Legris 3175 08 13 Male Connector 5/16 Tube 1/4 Pipe PK10

SKU CH-219T-W07AN MPN 3175

Nickel-plated brass push-fit connector joins 5/16 in tube to 1/4 in MBSPT thread, rated to 290 psi and 175 °F

  • TypeDrain Components
  • ColorNickel Plated Brass
  • Push-to-connect design speeds up vacuum line assembly
  • Nickel-plated brass body resists corrosion in harsh environments
  • Pre-applied thread sealant cuts installation time on MBSPT connections
  • Rated for 290 psi and 175 °F in demanding applications
  • Pack of ten fittings covers multiple repair or build jobs

Push-Fit Adapter for 5/16 Tube and 1/4 Pipe

This pack of ten nickel-plated brass connectors joins 5/16 inch tube to a 1/4 inch male BSPT thread using a push-to-connect design. The C36000 brass body includes pre-applied thread sealant for a secure seal. It suits pneumatic or vacuum lines in automotive and workshop plumbing.

Check tube diameter and thread type before ordering

Verify that your tubing has a 5/16 inch outer diameter and that the mating port uses a 1/4 inch male BSPT thread. The fitting relies on a push-to-connect seal rather than a compression nut, so the tube must be clean and cut squarely. Ensure the system pressure and temperature stay within the rated limits.

Rated for 290 psi and 175 Degrees F under

The connector maintains its seal at the maximum operating pressure of 290 psi and the maximum operating temperature of 175 Degrees F during continuous use. Nickel plating on the C36000 brass resists corrosion over long service periods. The pre-applied thread sealant remains effective without re-tightening.

Highlights

  • Push-to-connect design speeds up vacuum line assembly
  • Nickel-plated brass body resists corrosion in harsh environments
  • Pre-applied thread sealant cuts installation time on MBSPT connections
  • Rated for 290 psi and 175 °F in demanding applications
  • Pack of ten fittings covers multiple repair or build jobs

Specifications

TypeDrain Components
ColorNickel Plated Brass
BrandLegris
Model3175 08 13

Questions about this item

Does the pack of ten male connectors include any tubing or thread-seal tape, or must those be purchased separately?

The pack contains only the ten nickel-plated brass push-fit connectors with pre-applied thread sealant; 5/16 inch tubing and any additional sealing tape are not included and must be sourced separately.

How do I confirm that the 5/16 inch tube and 1/4 inch BSPT thread sizes match my existing pneumatic line?

Measure the tube outside diameter — it must be exactly 5/16 inch — and verify the mating port uses a 1/4 inch male BSPT thread; the connector’s push-to-connect end accepts the tube while the threaded end screws into the port.

Will the 290 psi pressure rating hold up on a shop compressor that cycles to 175 °F?

Yes — the brass body is rated for 290 psi maximum operating pressure and 175 °F maximum operating temperature, covering typical shop-air conditions.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.