We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Ten brass push-fit adapters with silver finish and pre-applied sealant

Legris

Legris 3175 04 14 Push-Fit Adapter Trap 5/32 in 290 PSI PK10

SKU CH-5ZWN-6AP74 MPN 3175

Connects 5/32 inch tubing to 1/4 inch NPT threads at 290 psi with push-fit convenience

  • TypeDrain Components
  • MaterialHAWA
  • Push-to-connect design speeds installation with 5/32 in tube fit
  • Brass C36000 body resists corrosion for long service life
  • Pre-applied thread sealant cuts assembly time on 1/4 in MNPT threads
  • Rated to 290 psi and 175 °F for demanding pneumatic lines
  • Pack of 10 fittings covers multiple connection points

Push-Fit Adapter Trap for 5/32 in Tubing

The Legris 3175 04 14 is a push-to-connect male adapter made from brass with a C36000 material grade. It joins 5/32 in outer-diameter tubing to a 1/4 in MNPT thread and comes in a pack of ten. The fitting includes pre-applied thread sealant for quicker installation.

Replaces Compression Fittings When Speed Matters

This adapter replaces traditional compression fittings where tool-free assembly and faster rework are priorities. The jump is worth it when you need a reliable seal up to 290 psi without tightening nuts or applying tape separately.

Holds Seal at 290 psi and 175 Degrees F

Under sustained pressure the brass body and pre-applied sealant maintain integrity at the rated 290 psi maximum operating pressure. The fitting also withstands continuous temperatures up to 175 degrees F without degradation of the connection.

Highlights

  • Push-to-connect design speeds installation with 5/32 in tube fit
  • Brass C36000 body resists corrosion for long service life
  • Pre-applied thread sealant cuts assembly time on 1/4 in MNPT threads
  • Rated to 290 psi and 175 °F for demanding pneumatic lines
  • Pack of 10 fittings covers multiple connection points

Specifications

TypeDrain Components
MaterialHAWA
BrandLegris
Model3175 04 14

Questions about this item

What tube size fits the push-to-connect side of this Legris 3175 04 14 adapter?

The push-to-connect side accepts 5/32 in outer diameter tube.

How do I install the 1/4 in MNPT thread correctly and what is the common mistake?

Thread the MNPT end into the female port by hand then tighten with a wrench; the pre-applied sealant means extra tape or paste is not needed and adding it can prevent a proper seal.

When should I replace the push-to-connect collet or the pre-applied thread sealant on this fitting?

Replace the fitting if the collet no longer grips the 5/32 in tube securely or if the pre-applied sealant on the 1/4 in MNPT thread is damaged or missing.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.