We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black Y-shaped push-fit fitting with one threaded male end and two tube connections, pack of 10

Legris

Legris 3148 60 14 Threaded Y Male 3/8 In OD PSI 290 PK10 trap

SKU CH-GKVC-VYR13 MPN 3148

Push-fit Y fitting joins a 1/4 NPT male thread to two 3/8 in push-to-connect ports for air, cutting fluids or inert gases at up to 290 PSI, supplied as a pack of 10

  • TypeDrain Components
  • MaterialHAWA
  • ColorBlack
  • Push-fit design speeds up pneumatic line assembly
  • 290 PSI rating handles demanding air and fluid systems
  • Pre-applied thread sealant cuts installation time on 1/4 in NPT port
  • Two 3/8 in push-to-connect branches simplify Y-configuration routing
  • Fibre-reinforced nylon body resists cutting fluids and inert gases

Push-Fit Wye Fitting for Air and Fluid Lines

This Legris 3148 60 14 threaded Y male fitting connects a 1/4 inch MNPT port to two 3/8 inch push-to-connect tubes. It suits pneumatic circuits, cutting-fluid delivery and inert-gas distribution in workshop and industrial settings. The pack contains ten pieces for multi-point installations.

Fiberglass-Reinforced Nylon Body

The black HAWA material resists corrosion and vibration while the pre-applied thread sealant on the male side removes the need for tape or paste during assembly. Push-to-connect ends on both branches allow tool-free tube insertion and release, speeding up routine reconfiguration or maintenance.

Ten-Piece Pack Simplifies Stock Management

Supplying ten identical fittings in one package lets technicians complete branched runs without sourcing individual units. Uniform 3/8 inch tube connections across both outlets reduce the variety of spare tubing and release tools that must be kept on hand.

Highlights

  • Push-fit design speeds up pneumatic line assembly
  • 290 PSI rating handles demanding air and fluid systems
  • Pre-applied thread sealant cuts installation time on 1/4 in NPT port
  • Two 3/8 in push-to-connect branches simplify Y-configuration routing
  • Fibre-reinforced nylon body resists cutting fluids and inert gases

Specifications

TypeDrain Components
MaterialHAWA
ColorBlack
BrandLegris
Model3148 60 14

Questions about this item

What thread standard does the 1/4 in MNPT side use and what pressure does it handle?

The 1/4 in MNPT male thread follows NPT taper standards and the fitting is rated for 290 PSI working pressure.

What tube size and clearance does the 3/8 in push-to-connect end need?

Each push-to-connect port accepts 3/8 in OD tubing and requires enough space for the collet to release; the black fiberglass-reinforced nylon body measures to standard Legris 3148 envelope dimensions.

How do I install the pre-sealed MNPT thread and avoid the common overtightening mistake?

Apply the pre-applied thread sealant to the 1/4 in MNPT male end, hand-tighten then add one to two turns with a wrench; pushing 3/8 in tubing into the two push-to-connect ports until it bottoms out completes the seal without tools.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.