We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black push-fit Y fitting with male thread and two 1/4 in ports, pack of 10

Legris

Legris 3148 56 14 Threaded Y Male 1/4 In OD PSI 290 PK10 trap

SKU CH-YKVS-T22ZN MPN 3148

Threaded Y male push-fit wye fitting for air, cutting fluids and inert gases, 1/4 in OD, 290 PSI, pack of 10

  • TypeDrain Components
  • MaterialHAWA
  • ColorBlack
  • Push-fit design enables fast installation without tools
  • Rated to 290 PSI for reliable air and fluid handling
  • Pre-applied thread sealant on the male NPT end saves assembly time
  • Fiberglass-reinforced nylon body resists corrosion and cutting fluids
  • Pack of ten fittings supports multiple connection points

Threaded Y Male Fitting

This Legris push-fit wye fitting connects a 1/4 inch male NPT thread to two 1/4 inch push-to-connect ports. The body is moulded from black fiberglass-reinforced nylon rated for 290 PSI. Pre-applied thread sealant is included on the male thread for quicker installation.

Air and fluid lines only

It suits pneumatic circuits, cutting-fluid delivery and inert-gas distribution where a single supply splits into two 1/4 inch tube runs. Builders needing a different thread size, a barb connection or a higher pressure rating should look at alternative fittings.

290 PSI working pressure

The 290 PSI rating is the key figure that decides whether this fitting matches the system pressure. Verify your circuit stays at or below this value before specifying the part.

Highlights

  • Push-fit design enables fast installation without tools
  • Rated to 290 PSI for reliable air and fluid handling
  • Pre-applied thread sealant on the male NPT end saves assembly time
  • Fiberglass-reinforced nylon body resists corrosion and cutting fluids
  • Pack of ten fittings supports multiple connection points

Specifications

TypeDrain Components
MaterialHAWA
ColorBlack
BrandLegris
Model3148 56 14

Questions about this item

Will the pre-applied thread sealant on the 1/4 in MNPT end need reapplication after repeated disassembly?

The pre-applied thread sealant is designed for initial installation; if the fitting is removed and reinstalled, fresh sealant or PTFE tape should be applied to maintain a leak-free joint.

At 290 PSI, which component reaches its pressure limit first during continuous operation?

The fiberglass-reinforced nylon body and push-to-connect collets are both rated to the stated 290 PSI, so the system pressure ceiling is the limiting factor rather than an individual component.

How much heat does the fitting transmit when 290 PSI air runs through it all day?

The fiberglass-reinforced nylon construction remains near ambient temperature under sustained 290 PSI air flow, adding negligible heat to the surrounding plumbing.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.