We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Pack of ten black push-fit elbow fittings, quarter-inch tube to quarter-inch pipe

Legris

Legris 3113 56 14 Male Elbow Trap 1/4In Tube 1/4In Pipe PK10

SKU CH-66ET-0DFVD MPN 3113

Push-fit elbow connects 1/4-inch tube to 1/4-inch NPT pipe with pre-applied sealant, rated to 290 psi and 175 °F, pack of ten

  • TypeDrain Components
  • MaterialHAWA
  • ColorBlack
  • Push-to-connect design speeds installation
  • 290 psi rating handles demanding vacuum lines
  • Pre-applied thread sealant prevents leaks instantly
  • Fiberglass-reinforced nylon resists heat to 175 °F
  • Pack of 10 fittings covers multiple jobs

Push-fit elbow fitting

This push-fit elbow connects 1/4 inch tubing to a 1/4 inch male NPT thread. The pack contains ten black fittings made from fiberglass-reinforced nylon. Each unit ships with pre-applied thread sealant for faster assembly. It suits vacuum applications up to 290 psi and 175 degrees Fahrenheit.

Pneumatic installers needing quick tube-to-thread

Technicians who value tool-free tube insertion will appreciate the push-to-connect design. The fixed 1/4 inch size on both ends limits use to matching tubing and port dimensions. Installers requiring other diameters, straight couplers, or metal bodies should look at alternative fittings.

290 psi maximum operating pressure

This pressure ceiling determines whether the fitting survives the intended vacuum or low-pressure pneumatic circuit. Systems that exceed 290 psi need a higher-rated component. The 175 degrees Fahrenheit temperature limit applies equally to the selection decision.

Highlights

  • Push-to-connect design speeds installation
  • 290 psi rating handles demanding vacuum lines
  • Pre-applied thread sealant prevents leaks instantly
  • Fiberglass-reinforced nylon resists heat to 175 °F
  • Pack of 10 fittings covers multiple jobs

Specifications

TypeDrain Components
MaterialHAWA
ColorBlack
BrandLegris
Model3113 56 14

Questions about this item

What tube and pipe sizes does the 1/4 in push-to-connect elbow accept?

The fitting takes a 1/4 in tube outer diameter on the push-to-connect side and a 1/4 in male NPT pipe thread on the other side.

How do you install the pre-applied thread sealant on the male pipe thread correctly?

Screw the 1/4 in MNPT end into the port by hand until the sealant contacts the threads, then tighten one to two turns with a wrench; do not add tape or paste over the factory coating.

When should the black fiberglass-reinforced nylon elbow be replaced under normal vacuum service?

Replace the fitting if the body shows cracking, the push-to-connect collet no longer grips the 1/4 in tube, or the pre-applied sealant has been disturbed during re-use.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.