We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black push-fit tee fitting with three ports, two push-to-connect and one male thread, pack of ten

Legris

Legris 3108 60 14 Male Branch Tee 3/8 in OD 290 PSI PK10 trap

SKU CH-F6SV-YZ8QK MPN 3108

A push-fit male branch tee with two 3/8 in tube ports and a 1/4 in MNPT branch, rated to 290 PSI, supplied in a pack of 10

  • TypeDrain Components
  • MaterialHAWA
  • ColorBlack
  • Push-to-connect design enables tool-free installation on 3/8 in tubing
  • Pre-applied thread sealant on 1/4 in MNPT branch saves assembly time
  • 290 PSI rating supports demanding air and cutting-fluid lines
  • Fiberglass-reinforced nylon body resists corrosion and vibration
  • Pack of 10 fittings covers multiple connection points

Push-Fit Branch Tee for Air and Fluids

This push-fit branch tee connects two 3/8 in outer-diameter tubes to a 1/4 in male NPT port. The fitting is moulded from black fiberglass-reinforced nylon and rated for 290 PSI. Pre-applied thread sealant is included on the threaded end. Supplied in a pack of ten pieces.

Installers needing a compact three-way junction

Suited for pneumatic lines, cutting-fluid systems and inert-gas circuits where a push-to-connect joint speeds assembly. Not intended for applications that require a different thread size, a straight coupling or a higher pressure rating than 290 PSI.

3/8 in tube to 1/4 in MNPT branch connection

The tee joins two 3/8 in push-fit ports to a single 1/4 in male NPT branch. This specific combination of tube diameter and thread size determines whether the fitting matches the port and tubing in your system.

Highlights

  • Push-to-connect design enables tool-free installation on 3/8 in tubing
  • Pre-applied thread sealant on 1/4 in MNPT branch saves assembly time
  • 290 PSI rating supports demanding air and cutting-fluid lines
  • Fiberglass-reinforced nylon body resists corrosion and vibration
  • Pack of 10 fittings covers multiple connection points

Specifications

TypeDrain Components
MaterialHAWA
ColorBlack
BrandLegris
Model3108 60 14

Questions about this item

How do I install the 3/8 in push-to-connect ends on the 3108 tee, and what step is often missed?

Push each 3/8 in tube firmly into the fitting until it seats; the step people miss is not pushing past the first grip ring, so the tube can pull out under pressure.

What maintenance or replacement will the Legris 3108 60 14 need over time?

Inspect the pre-applied thread sealant on the 1/4 in MNPT branch and the fiberglass-reinforced nylon body for cracks; replace the fitting if sealant dries out or the body shows stress whitening.

What limit appears first when the tee runs continuously at 290 PSI with air or cutting fluids?

The 290 PSI pressure rating is the first limit; sustained operation at or above that pressure can cause the push-to-connect seals or the nylon body to fail.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.