We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black push-fit tee fitting with two 1/4 inch tube ends and one 1/8 inch threaded end

Legris

Legris 3108 56 10 Male Tee Trap 1/4In Tube 1/8In Pipe PK10

SKU CH-WZ52-Y1KDX MPN 3108

Push-fit male tee connects two 1/4 in tubes to a 1/8 in pipe thread, supplied in a pack of 10

  • TypeDrain Components
  • MaterialHAWA
  • Push-to-connect design speeds installation on 1/4 in tubing
  • Pre-applied thread sealant ensures leak-free 1/8 in MBSPT connection
  • Fiberglass-reinforced nylon body resists cutting fluids and inert gases
  • Black finish identifies the fitting in pneumatic circuits
  • Pack of ten fittings covers multiple branch points

Push-Fit Tee Fitting

This push-fit tee fitting connects two 1/4 inch tubes and a 1/8 inch male BSPT thread. The body is made from fiberglass-reinforced nylon and comes in black. Pre-applied thread sealant is included on the threaded end. Supplied in a pack of ten pieces.

Pneumatic and fluid transfer use

Suits installers routing air, cutting fluids or inert gases through 1/4 inch tubing with a single threaded branch. Not for systems that require metal-bodied fittings or larger tube diameters. Buyers needing a straight connector or an elbow should look at a different fitting type.

1/4 in tube and 1/8 in thread

The critical specification is the combination of 1/4 inch push-to-connect ports on two sides and a 1/8 inch male BSPT thread on the third. Verify these exact sizes match the tubing and port you are joining.

Highlights

  • Push-to-connect design speeds installation on 1/4 in tubing
  • Pre-applied thread sealant ensures leak-free 1/8 in MBSPT connection
  • Fiberglass-reinforced nylon body resists cutting fluids and inert gases
  • Black finish identifies the fitting in pneumatic circuits
  • Pack of ten fittings covers multiple branch points

Specifications

TypeDrain Components
MaterialHAWA
BrandLegris
Model3108 56 10

Questions about this item

What tube size fits the two push-to-connect ends of the Legris 3108 56 10 tee?

Both push-to-connect ends accept 1/4 in outside-diameter tube.

How do you install the MBSPT end without leaks?

Thread the 1/8 in MBSPT end into the female port; the pre-applied sealant seals on tightening — do not add tape or paste.

When should the fiberglass-reinforced nylon body be replaced?

Replace if the body shows cracks, the collet teeth no longer grip the tube, or the pre-applied sealant on the MBSPT thread is worn away.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.