We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black push-fit tee fitting with two 6 mm tube ends and one 1/8 NPT male thread

Legris

Legris 3108 06 11 Male Branch Tee 6mm OD 1/8 NPT PK10 trap

SKU CH-DQ22-SMSEQ MPN 3108

Push-fit branch tee connects two 6 mm tubes to a 1/8 NPT male thread in black fiberglass-reinforced nylon, pack of ten

  • TypeDrain Components
  • MaterialHAWA
  • ColorBlack
  • Push-to-connect design speeds up installation without tools
  • Pre-applied thread sealant eliminates separate sealing steps
  • 6 mm tube connections suit compact pneumatic lines
  • 1/8 NPT male branch integrates with standard ports
  • Pack of ten fittings covers multiple connection points

6 mm Push-Fit Branch Tee

This Legris 3108 06 11 fitting connects two 6 mm outer-diameter tubes to a 1/8 NPT male thread in a single branch-tee body. The push-to-connect ends on the tube sides allow tool-free installation, while the threaded end includes pre-applied sealant for a secure seal. Supplied as a pack of 10 black fiberglass-reinforced nylon units, it is rated for air, cutting fluids and inert gases.

Not for metric-thread or larger-tube systems

Builders who need a metric-threaded port, a different tube diameter or an all-female configuration cannot use this fitting. The fixed 1/8 NPT male thread and 6 mm push-fit ends make it unsuitable for those plumbing layouts. It also does not suit applications that require metal bodies or higher-pressure ratings beyond the published scope.

6 mm tube size with 1/8 NPT branch

The single specification that decides fitment is the combination of 6 mm push-to-connect tube ports and a 1/8 NPT male branch thread. Verify that both tube lines and the mating port match these exact sizes before ordering.

Highlights

  • Push-to-connect design speeds up installation without tools
  • Pre-applied thread sealant eliminates separate sealing steps
  • 6 mm tube connections suit compact pneumatic lines
  • 1/8 NPT male branch integrates with standard ports
  • Pack of ten fittings covers multiple connection points

Specifications

TypeDrain Components
MaterialHAWA
ColorBlack
BrandLegris
Model3108 06 11

Questions about this item

Will the push-to-connect seals on the 6 mm ports need periodic replacement?

The fiberglass-reinforced nylon body and push-to-connect design are intended for long service; inspect O-rings during routine maintenance and replace if wear or leakage appears.

What pressure or temperature limit is reached first during continuous air or cutting-fluid use?

The fitting carries no published pressure or temperature rating in the supplied data, so the system designer must verify limits against the tubing and application requirements.

Does the pre-applied thread sealant on the 1/8 NPT end degrade with heat from all-day operation?

The sealant is factory-applied for the initial installation; prolonged heat cycling may reduce its effectiveness, so re-check joint tightness after extended running periods.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.