We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black push-fit tee fitting with three ports, pack of 10

Legris

Legris 3103 62 22 Male Run Tee 1/2 in OD 290 PSI Pack of 10

SKU CH-A8SY-Q80CT MPN 3103

Push-fit male run tee connects 1/2 in OD tubing with 1/2 in NPT thread, rated to 290 PSI, pack of 10

  • TypeDrain Components
  • MaterialHAWA
  • ColorBlack
  • Push-fit installation speeds up plumbing work
  • 290 PSI rating handles demanding air and fluid lines
  • Pre-applied thread sealant cuts assembly time
  • Fiberglass-reinforced nylon body resists corrosion and impact
  • Pack of 10 fittings covers multiple connection points

Push-fit tee for air and fluid lines

This Legris 3103 male run tee connects three 1/2-inch OD tubes using push-to-connect ends on two branches and a 1/2-inch MNPT thread on the run. The fiberglass-reinforced nylon body handles air, cutting fluids and inert gases up to 290 PSI. Pre-applied thread sealant on the MNPT end speeds installation. The pack contains ten fittings.

Suits pneumatic and coolant circuits needing

Installers who need a compact tee with a threaded outlet for direct port entry will find this part convenient. Systems that require all-metal construction, higher pressure ratings or a different thread standard should consider alternative fittings.

290 PSI working pressure rating

This single figure defines the maximum pressure the fitting can safely contain in air, cutting-fluid or inert-gas service. Exceeding it risks leaks or failure, so verify your system pressure before specifying this tee.

Highlights

  • Push-fit installation speeds up plumbing work
  • 290 PSI rating handles demanding air and fluid lines
  • Pre-applied thread sealant cuts assembly time
  • Fiberglass-reinforced nylon body resists corrosion and impact
  • Pack of 10 fittings covers multiple connection points

Specifications

TypeDrain Components
MaterialHAWA
ColorBlack
BrandLegris
Model3103 62 22

Questions about this item

How often should the pre-applied thread sealant on the 1/2 in MNPT end be inspected or replaced?

The pre-applied thread sealant is designed for the initial installation; re-sealing requires removing the fitting and applying fresh PTFE tape or pipe thread compound to the male threads.

At sustained pressure near the 290 PSI rating, which component reaches its limit first?

The fiberglass-reinforced nylon body and push-to-connect collets are rated for the full 290 PSI working pressure; the sealant and thread engagement on the 1/2 in MNPT end typically become the limiting factor under continuous high-pressure cycling.

Does the black fiberglass-reinforced nylon body get hot or make noise when air runs through it all day?

The fitting body remains near ambient temperature with compressed air flow and produces no audible noise; only the connected tubing may transmit slight vibration from the source compressor.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.