Legend Valve
Legend Valve 800-876 T-88 A&D Eliminator Body B accessory
A T-88 radiator accessory with air vent, check, fill and purge valves plus connector nuts and washer
- T-88 model integrates air vent, check, fill and purge valve
- Connector nuts and washer included for complete installation readiness
- New condition ensures full manufacturer specification performance
- Legend Valve brand delivers trusted HVAC component reliability
- California Proposition 65 listed chemical content disclosed for safety awareness
Eliminator Body B accessory
The Legend Valve 800-876 T-88 A&D Eliminator Body B accessory is a new HVAC component designed for heating system installations. It serves installers and maintenance technicians who require a complete body assembly with integrated air vent, check, fill and purge valves plus connector nuts and washer.
Thermals, noise and power
This accessory operates passively within a hydronic circuit and therefore produces no mechanical noise or electrical power draw. Thermal performance depends entirely on the boiler and radiator specifications of the wider system.
California Proposition 65 notice
The product carries a California Proposition 65 warning because it contains a chemical known to the state to cause cancer and birth defects or other reproductive harm. Buyers who need a component without this regulatory designation should select an alternative part.
Highlights
- T-88 model integrates air vent, check, fill and purge valve
- Connector nuts and washer included for complete installation readiness
- New condition ensures full manufacturer specification performance
- Legend Valve brand delivers trusted HVAC component reliability
- California Proposition 65 listed chemical content disclosed for safety awareness
Specifications
| Brand | LEGEND VALVE |
|---|
Questions about this item
How do I install the T-88 A&D Eliminator Body B and what step is commonly missed?
Install the T-88 body by threading the connector nuts onto the radiator ports with the included washers, then attach the air vent, check valve, and fill and purge valve. The step often missed is fitting the washer on each connector nut before tightening, which prevents leaks at the joint.
What maintenance or replacement will the T-88 A&D Eliminator Body B need over time?
The air vent, check valve, and fill and purge valve are serviceable components that may require periodic inspection and replacement if they leak or fail to operate. The body itself is brass and typically does not need replacement unless physically damaged.
What is the first limit that appears on the T-88 A&D Eliminator Body B during sustained heating cycles?
Under continuous heating cycles, the rubber washers on the connector nuts and the seals inside the air vent and check valve degrade first, leading to minor weeping or loss of air‑venting function before the brass body shows any stress.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
