We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Brass plumbing adapter with PEX and sweat ends

Legend Valve

Legend Valve 460-628NL 2" PEX x 2" Sweat Adapter No Lead DZR Forged Brass Plumbing

SKU CH-GJC9-VAVHJ

Connects 2" PEX tubing to a 2" sweat copper joint using no-lead DZR forged brass

  • 2" PEX to sweat connection simplifies copper-to-PEX transitions
  • No-lead DZR forged brass resists dezincification for potable water
  • New condition ensures full factory specifications on installation
  • Model 460-628NL identifies exact fitting for ordering accuracy
  • Legend Valve brand backs consistent manufacturing quality

Legend Valve 460-628NL Adapter

This Legend Valve 460-628NL adapter connects 2" PEX tubing to a 2" sweat copper joint. The no-lead DZR forged brass body meets low-lead plumbing requirements. It is intended for installers joining cross-linked polyethylene to copper in potable water systems.

Replacing threaded transition fittings

This fitting replaces a separate threaded adapter and union when a direct sweat-to-PEX joint is preferred. The jump is worth it when the installer wants fewer leak paths and a permanent soldered connection on the copper side. It is not for systems that require a removable compression or push-fit connection on the copper end.

Check tubing type and local code

Verify that the PEX tubing is rated for the same pressure and temperature class as the fitting before ordering. Confirm that local plumbing codes accept no-lead DZR forged brass for the intended application. Ensure the copper pipe is clean and properly prepared for a reliable solder joint.

Highlights

  • 2" PEX to sweat connection simplifies copper-to-PEX transitions
  • No-lead DZR forged brass resists dezincification for potable water
  • New condition ensures full factory specifications on installation
  • Model 460-628NL identifies exact fitting for ordering accuracy
  • Legend Valve brand backs consistent manufacturing quality

Specifications

BrandLEGEND VALVE

Questions about this item

What pipe sizes does the 2" PEX x 2" sweat adapter connect?

The fitting joins two-inch PEX tubing to a two-inch copper sweat connection.

Which steps are required to install the sweat end of this brass adapter?

Clean the copper pipe, apply flux, slide the adapter on, then heat the joint evenly until solder flows into the cup.

How does the DZR forged brass construction affect long-term service?

Dezincification-resistant brass resists corrosion in aggressive water, so the fitting typically lasts the life of the plumbing system without replacement.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.