Legend Valve 450-298P Press Reducing Tee 2-1/2x2-1/2x1/2

Press Reducing Tee 2-1/2x2-1/2x1/2

This press reducing tee joins a 1/2-inch branch to a 2-1/2-inch main run in plumbing systems. It is intended for installers who need a factory-made reduction without field fabrication. The Legend Valve 450-298P model carries a California Proposition 65 notice for chemicals linked to cancer and reproductive harm. The product ships new from the manufacturer.

Press Connection Build Quality

The press design creates a permanent, leak-resistant joint when compressed with the correct tool, eliminating the need for solder or thread sealant. Stainless construction resists corrosion in potable water and hydronic applications. Because the joint is pressed, disassembly is not practical, so alignment must be accurate before the tool is cycled. The reducing geometry keeps flow disturbance low at the branch take-off.

Pre-Installation Checks

Verify that the piping material and schedule match the press profile required by the fitting. Confirm that the 2-1/2-inch and 1/2-inch tube ends are cut square, deburred and marked to the correct insertion depth. Ensure a calibrated press tool with the proper jaw set is available on site. Review the Proposition 65 warning and apply any site-specific handling procedures before work begins.