We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black cast iron reducing elbow with female threaded ends at right angle

Legend Valve

Legend Valve 350-135 3" x 2" Black Reducing Elbow 90° FNPT

SKU CH-M951-66Y6Y

A 3" x 2" black reducing elbow with 90° FNPT connections for changing pipe direction and size

  • Reduces pipe size from 3" to 2
  • 90° elbow changes flow direction efficiently
  • FNPT threads on both ends for secure fit
  • Black SA finish resists corrosion in plumbing systems
  • New condition ensures clean, undamaged threads ready for install

3" x 2" Black Reducing Elbow

This Legend Valve 350-135 fitting connects a 3-inch female NPT pipe to a 2-inch female NPT pipe at a 90-degree angle. The black finish suits standard plumbing installations where a reducing elbow is required. It is intended for installers joining dissimilar pipe sizes in water, gas or oil lines.

Threaded installation with sealant

The FNPT x FNPT threads accept standard pipe tape or thread sealant for a leak-free joint. Misalignment of the two pipe runs is the most common issue; ensure both pipes are cut square and supported before tightening. Over-tightening can crack the casting, so stop when resistance increases sharply.

Verify pipe sizes and thread standard

Confirm that the existing pipes measure 3 inches and 2 inches nominal size and use NPT threads. The fitting is not compatible with BSP, compression or push-fit systems. Check local codes for any restrictions on the material in potable-water applications.

Highlights

  • Reduces pipe size from 3" to 2
  • 90° elbow changes flow direction efficiently
  • FNPT threads on both ends for secure fit
  • Black SA finish resists corrosion in plumbing systems
  • New condition ensures clean, undamaged threads ready for install

Specifications

BrandLEGEND VALVE

Questions about this item

How can I confirm the 90° reducing elbow is seated correctly after threading it onto the 3" and 2" FNPT connections?

Hand-tighten each female NPT end onto the matching male pipe threads, then use a pipe wrench for one to two additional turns; the joint should feel firm with no visible gap between the threads and the fitting body.

What comes in the package and are any sealants or extra couplings required?

The box contains the single 3" x 2" black reducing elbow; thread sealant tape or pipe dope for the FNPT joints must be purchased separately.

The listing shows numbers 350-135 — which version should I select for a 3" to 2" reduction?

The part number 350-135 identifies this exact 3" x 2" black 90° reducing elbow with FNPT x FNPT ends; no other size or angle variant is associated with that code.

More in Fittings & Couplings

Similar items

Same shelf, same checkout — eight coins and a 30-minute rate lock.