We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Brass 1-1/4 inch flare flare quarter bend fitting

Legend Valve

Legend Valve 313-316NL T4401NL 1-1/4 Flare x Flare 1/4 Bend

SKU CH-94E0-XRC1A

1-1/4 inch no-lead bronze flare-to-flare quarter bend for potable water lines

  • No-lead bronze construction meets Prop 65 compliance
  • 1-1/4 inch flare-to-flare connection simplifies installation
  • Quarter-bend design routes tubing in tight spaces
  • T-4401NL model ensures consistent Legend Valve quality
  • New condition guarantees full factory performance

Legend Valve 313-316NL Flare Bend

The Legend Valve 313-316NL T4401NL is a no-lead bronze fitting designed to join two flare connections in a plumbing system. It provides a quarter-bend configuration for directional routing. The component is supplied new and carries California Proposition 65 warnings for chemicals known to cause cancer and reproductive harm.

Suitable Applications and Limitations

This fitting suits installers needing a flare-to-flare quarter bend in a no-lead bronze material for potable water or compatible fluid lines. It is not intended for buyers who require a different bend angle, a different connection type such as compression or sweat, or a fitting without Proposition 65 chemical warnings.

Critical Specification

The defining specification is the 1-1/4 inch flare-by-flare quarter bend in no-lead bronze, identified by model numbers 313-316NL and T4401NL, which determines compatibility with existing flare tubing and regulatory requirements.

Highlights

  • No-lead bronze construction meets Prop 65 compliance
  • 1-1/4 inch flare-to-flare connection simplifies installation
  • Quarter-bend design routes tubing in tight spaces
  • T-4401NL model ensures consistent Legend Valve quality
  • New condition guarantees full factory performance

Specifications

BrandLEGEND VALVE

Questions about this item

How is the 1-1/4" flare x flare 1/4 bend installed, and what step do people often get wrong?

Clean both flare faces, apply thread sealant sparingly to the male threads only, hand-tighten then finish with two wrenches; the common error is over-tightening the flare nut and cracking the seat.

What maintenance or replacement will the no-lead bronze fitting need later?

Inspect annually for green patina or seepage at the flare seats; replace the fitting if corrosion penetrates the bronze wall or if the flare nut rounds off during service.

What limit appears first on the T-4401NL under sustained pressure and thermal cycling?

The flare-to-flare joint typically weeps before the bronze body yields; repeated expansion and contraction can loosen the nut, so re-torque after the first heat cycle.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.