We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Chrome-plated brass pipe nipple, 1/2 inch diameter, 4-1/2 inches long, shiny silver finish

Legend Valve

Legend Valve 311-067CNL 1/2" x 4-1/2" Chrome Nipple NL trap

SKU CH-3407-WYZB6

A 1/2 inch by 4-1/2 inch no-lead chrome plated brass pipe nipple for plumbing drain and trap connections

  • ColorTransparent
  • No-lead brass protects drinking water safety
  • Chrome plating resists corrosion for long service
  • 1/2-inch thread fits standard plumbing connections
  • 4-1/2-inch length suits common trap installations
  • New condition ensures clean, undamaged threads

Plumbing nipple for drain connections

This 1/2" x 4-1/2" chrome-plated brass nipple connects drain and trap components in plumbing installations. The no-lead construction meets Proposition 65 requirements for safer drinking water contact. It suits residential and light-commercial projects where a short, straight connector is needed.

Capacity and headroom for flow

The 1/2" bore handles typical sink, lavatory and fixture drainage without restriction. Length of 4-1/2" provides enough reach for standard trap-to-wall or trap-to-floor alignments. Chrome-plated brass resists corrosion in wet environments but is not rated for pressurised supply lines or high-temperature discharge.

Threaded interface practical limits

Male NPT threads on each end accept standard 1/2" female fittings such as trap adapters, couplings or wall elbows. Brass threads gall if overtightened, so hand-tight plus one turn with a wrench is the practical limit. The fitting is not intended for gas service, fuel lines or any application outside gravity drainage.

Highlights

  • No-lead brass protects drinking water safety
  • Chrome plating resists corrosion for long service
  • 1/2-inch thread fits standard plumbing connections
  • 4-1/2-inch length suits common trap installations
  • New condition ensures clean, undamaged threads

Specifications

ColorTransparent
BrandLEGEND VALVE

Questions about this item

Will the 1/2" chrome nipple connect to my existing 1/2" brass fittings without adapters?

Yes, the 1/2" threads match standard 1/2" brass fittings so it threads directly onto the pipes you already have.

How can I confirm the nipple is seated correctly after installation?

Tighten until the chrome body sits flush against the fitting faces and no threads show; then run water and check the joint for drips.

Does the box include thread sealant or do I need to buy pipe tape separately?

Only the chrome plated brass nipple is supplied; thread seal tape or compound must be purchased separately.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.