Legend Valve
Legend Valve 201-426 PVC Ball Valve 1-1/4" T-602
A 1-1/4" PVC ball valve for controlling fluid flow in air compressor and vacuum pump systems
- 1-1/4" T-602 PVC ball valve for reliable flow control
- Legend Valve brand manufacturing ensures consistent quality
- New condition guarantees factory-fresh performance
- California Proposition 65 warning indicates regulated chemical content
- Model 201-426 provides precise identification for ordering
Valve for compressed-air systems
This 1-1/4 inch PVC ball valve controls airflow in compressor and vacuum-pump installations. The quarter-turn handle gives quick on-off operation for maintenance or isolation tasks. It suits workshops and light-industrial sites that run standard shop air lines.
Low-friction flow path
The full-port PVC body reduces pressure drop so the compressor runs closer to its rated output. No metal internals contact the air stream, so corrosion noise is absent and power draw stays predictable. The material resists moisture carry-over from the tank.
Replaces worn shut-off valves
Swapping a leaking gate or globe valve restores system pressure and cuts compressor cycle time. The step is worth it when pressure loss at the tool exceeds acceptable limits or when the old valve seizes during emergency shut-off. Not for builders who need automated actuation or stainless-steel construction.
Highlights
- 1-1/4" T-602 PVC ball valve for reliable flow control
- Legend Valve brand manufacturing ensures consistent quality
- New condition guarantees factory-fresh performance
- California Proposition 65 warning indicates regulated chemical content
- Model 201-426 provides precise identification for ordering
Specifications
| Brand | LEGEND VALVE |
|---|
Questions about this item
How is the 1-1/4" T-602 PVC ball valve installed, and what step is often missed?
Apply PVC primer and solvent cement to both the pipe ends and the valve sockets, then push fully home and hold for the recommended set time; the step often missed is using primer before cement, which can cause joint failure.
What maintenance or replacement will the 1-1/4" T-602 PVC ball valve need later?
Inspect the handle and stem seal periodically for stiffness or drips; if the PTFE seats wear or the ball scores, replace the entire valve because it is not designed for internal part servicing.
What limit appears first on the 1-1/4" T-602 PVC ball valve under sustained pressure cycles?
The PVC body and seals reach their temperature and pressure rating ceiling before the ball or stem, so sustained high-pressure cycling will degrade the socket joints and seat material first.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
