Legend Valve
Legend Valve 102-212 3/8" FL x 1/2" MIP T-3000 Forged Brass Gas Valve
Forged brass gas valve connects 3/8-inch flare to 1/2-inch male pipe threads for fuel-line service
- Forged brass construction resists corrosion and high pressure
- 3/8" flare to 1/2" male pipe thread fits standard gas lines
- T-3000 rating supports demanding fuel applications
- New condition ensures reliable performance from first use
- California Proposition 65 notice discloses regulated chemical content
Gas Valve for Fuel Line Connections
This forged brass valve connects a 3/8 inch flare fitting to a 1/2 inch male pipe thread. It is rated T-3000 for gas service and carries the Legend Valve 102-212 part number. The component is supplied new and intended for installation in fuel distribution systems. California Proposition 65 warnings apply for cancer and reproductive harm.
Suited for Gas Piping Installers
Plumbers and HVAC technicians assembling or repairing gas lines will find the matching flare and thread ends convenient. The T-3000 rating covers typical residential and light commercial pressures. Buyers who need a different thread size, a female outlet, or a valve rated for higher pressure classes should look elsewhere.
T-3000 Pressure Rating Decides Fit
The single specification that determines suitability is the T-3000 designation stamped on the forged brass body. This rating confirms the valve meets the required standard for the intended gas pressure. Verify that your system design calls for a T-3000 component before purchasing.
Highlights
- Forged brass construction resists corrosion and high pressure
- 3/8" flare to 1/2" male pipe thread fits standard gas lines
- T-3000 rating supports demanding fuel applications
- New condition ensures reliable performance from first use
- California Proposition 65 notice discloses regulated chemical content
Specifications
| Brand | LEGEND VALVE |
|---|
Questions about this item
How do I install the 3/8 inch flare to 1/2 inch MIP T-3000 forged brass gas valve, and what step is often missed?
Apply pipe thread sealant to the 1/2 inch MIP threads and flare sealant to the 3/8 inch flare face, then tighten both connections to spec; the step often missed is lubricating the flare nut before assembly.
What maintenance or replacement will the T-3000 forged brass gas valve need later?
Inspect the valve annually for seat leakage, handle stiffness, or corrosion on the forged brass body; replace the unit if the stem seal weeps or the ball shows pitting.
What limit appears first on the T-3000 forged brass gas valve under sustained use?
The 3000 psi pressure rating is the primary limit; sustained operation near that pressure accelerates seat wear and can cause the stem packing to leak first.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
