Legend Valve
Legend Valve 102-118 1/2"FL x 3/4"FNPT T-3000 Forged Brass Gas Valve
A 1/2"FL x 3/4"FNPT T-3000 forged brass gas valve for fuel-line control
- Forged brass construction resists corrosion for long service life
- T-3000 rating supports high-pressure gas applications safely
- 1/2" flare by 3/4" FNPT ends fit standard piping
- New condition ensures full factory performance from first use
- California Proposition 65 warning informs safe handling practices
Gas Valve Specification
The Legend Valve 102-118 is a forged brass gas valve built with a 1/2" FL inlet and a 3/4" FNPT outlet. It carries a T-3000 rating and is supplied in new condition for use in compatible piping systems.
Suitable Installations
This valve suits installers who need a forged brass body with the stated flange and thread combination. It is not for buyers who require different connection sizes, alternative pressure ratings, or materials other than forged brass.
Capacity and Limits
The T-3000 designation indicates the pressure class this valve is designed to handle. It runs out of spec when system pressure exceeds that rating or when piping does not match the 1/2" FL by 3/4" FNPT configuration.
Highlights
- Forged brass construction resists corrosion for long service life
- T-3000 rating supports high-pressure gas applications safely
- 1/2" flare by 3/4" FNPT ends fit standard piping
- New condition ensures full factory performance from first use
- California Proposition 65 warning informs safe handling practices
Specifications
| Brand | LEGEND VALVE |
|---|
Questions about this item
What thread connections must my existing piping provide for the 102-118 valve to install without adapters?
The valve requires a 1/2 inch flare male on one side and a 3/4 inch FNPT female on the other, so your piping must present matching flare and NPT threads.
Can the T-3000 forged brass valve remain in line with an older steel gas cock that uses the same 3/4 inch FNPT thread?
Yes, the 3/4 inch FNPT inlet matches the older cock's outlet; use pipe sealant rated for gas and tighten to the fitting manufacturer's torque value.
After threading the 1/2 inch flare and 3/4 inch FNPT ends, how do I verify the T-3000 valve is sealing properly?
Pressurise the line, brush leak-detection fluid on both joints and the valve body, and confirm no bubbles form at the rated pressure.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
