Legend Valve
Legend Valve 101-623 1/2 inch T-1007 forged brass full port ball valve FNPT sweat
A 1/2 inch forged brass full port ball valve with FNPT and sweat connections
- Forged brass body resists corrosion for long service life
- Full-port design maintains unrestricted flow through the valve
- FNPT and sweat ends allow flexible piping connections
- T-1007 model built for reliable shut-off performance
- California Proposition 65 notice included for regulatory awareness
Half-inch forged brass valve
The Legend Valve 101-623 is a 1/2 inch T-1007 forged brass full port ball valve designed for plumbing and compressed-air systems. Its FNPT by sweat connection joins threaded pipe to copper tubing without adapters. Installers and maintenance crews use it where a straight-through flow path and reliable shut-off are required.
Forged brass body and full port
The forged brass construction resists corrosion and handles typical line pressures in air compressor and vacuum pump installations. A full port bore matches the pipe inner diameter so pressure drop stays minimal across the valve. The quarter-turn handle gives quick visual confirmation of open or closed position during daily checks.
Verify thread and solder compatibility
Confirm that the female NPT threads match the male threaded fitting on your existing line and that the sweat end suits the copper tube diameter you are joining. The product carries a California Proposition 65 warning for chemicals known to cause cancer and reproductive harm, so follow local handling and ventilation rules. Orders below seventy-five dollars may incur a shipping charge from the manufacturer.
Highlights
- Forged brass body resists corrosion for long service life
- Full-port design maintains unrestricted flow through the valve
- FNPT and sweat ends allow flexible piping connections
- T-1007 model built for reliable shut-off performance
- California Proposition 65 notice included for regulatory awareness
Specifications
| Brand | LEGEND VALVE |
|---|
Questions about this item
What connection standard does the FNPT x Sweat valve use?
It uses a female NPT thread on one end and a sweat copper fitting on the other, capping the joint at the pipe diameter.
What pipe size fits the 1/2 inch forged brass body?
The valve body accepts 1/2 inch nominal pipe for both the threaded and sweat connections.
How is the sweat end installed and what step is often missed?
Clean the copper tube, apply flux, insert fully into the sweat cup, then heat evenly and feed solder until the joint fills completely.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
