Legend Valve
Legend Valve 101-423 1/2 S-2000 CXC Full Port Ball Valve
Forged brass full-port ball valve sized 1/2 inch for reliable flow control
- Forged brass body resists corrosion and extends service life
- Full port design allows unrestricted flow for maximum system efficiency
- 1/2 inch connection fits standard piping without adapters
- S-2000 series built for reliable shut-off in compressed air lines
- California Proposition 65 warning indicates chemical content awareness
Product Identity
The Legend Valve 101-423 is a 1/2 inch forged brass full port ball valve built for air compressor and vacuum pump systems. It suits technicians and facility managers who need reliable flow control in pneumatic installations.
Upgrade Context
This valve replaces worn or leaking shut-off valves in existing compressed air lines where full-bore flow is required. The jump is worth it when the current valve restricts volume or fails to seal under 2000 pressure ratings.
Installation Notes
Threaded connections allow direct installation into standard pipework without special tools. The forged brass body resists stripping during tightening. California Proposition 65 warnings indicate the presence of chemicals linked to cancer and reproductive harm, so handle with gloves and wash hands after fitting.
Highlights
- Forged brass body resists corrosion and extends service life
- Full port design allows unrestricted flow for maximum system efficiency
- 1/2 inch connection fits standard piping without adapters
- S-2000 series built for reliable shut-off in compressed air lines
- California Proposition 65 warning indicates chemical content awareness
Specifications
| Brand | LEGEND VALVE |
|---|
Questions about this item
What pipe size does the 1/2 S-2000 full-port ball valve connect to?
The valve is built for 1/2-inch copper pipe with CXC solder ends, so it fits standard half-inch copper tubing.
How do I install the 101-423 forged brass ball valve correctly?
Clean and flux both copper ends, slide the valve on, then sweat the joints evenly; the step most people rush is heating both sockets fully before applying solder.
When will the 1/2 S-2000 ball valve need seal maintenance or replacement?
The PTFE seats inside the forged brass body typically last for years; inspect for seepage around the stem packing and replace the valve if internal leakage appears.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
