Legend Valve
Legend Valve 101-215NL 1" P-202NL Press Drainable Ball Valve
No-lead forged brass press ball valve with drain for potable water systems
- 1" no-lead forged brass press ball valve with drain
- Press connection enables fast, flameless installation on copper tubing
- Drainable design allows system drainage without valve removal
- Lead-free brass meets low-lead plumbing requirements
- California Proposition 65 warning applies to this product
1" No-Lead Brass Press Ball Valve
This 1" press ball valve is built from no-lead forged brass for potable-water and hydronic systems. The press-to-connect design suits installers who want a fast, flame-free joint on copper tube. It meets low-lead requirements for drinking-water applications.
Press connection with integral drain port
The press end eliminates soldering, reducing installation time and fire-risk on site. A built-in drainable port allows line drainage or pressure relief without adding a separate fitting. Forged brass body resists dezincification and handles typical commercial pressure ranges.
No-lead alloy and California Proposition 65 notice
The no-lead brass alloy satisfies federal and state lead-free mandates for potable water. California Proposition 65 warnings apply because the product contains chemicals identified by the state as causing cancer and reproductive harm. No additional accessories or software are bundled with the valve.
Highlights
- 1" no-lead forged brass press ball valve with drain
- Press connection enables fast, flameless installation on copper tubing
- Drainable design allows system drainage without valve removal
- Lead-free brass meets low-lead plumbing requirements
- California Proposition 65 warning applies to this product
Specifications
| Brand | LEGEND VALVE |
|---|
Questions about this item
What does the 1" P-202NL press connection mean for installation?
The 1" P-202NL designation indicates a press-fit connection for 1-inch tubing using compatible press tools, creating a permanent, leak-tight joint without soldering.
What clearance is needed for the drainable ball valve body?
The forged brass body requires enough pipe run to accommodate the valve length plus tool access for the press jaws; the drain port adds minimal extra height.
How is the drain port used during system commissioning?
After pressing the valve onto the pipe, open the drain cap to purge air or debris, then close it before pressurising the line.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
