Legend Valve
Legend Valve 101-067 T-1002 1-1/2" forged brass full port ball valve
A 1-1/2" forged brass full port ball valve with gland follower design for air compressor and vacuum pump systems
- Full port design maximises flow capacity
- Forged brass body resists corrosion and wear
- Gland follower stem seal prevents leakage
- 1-1/2 inch connection fits standard piping
- California Proposition 65 chemical warning applies
Valve for air-compressor systems
This 1-1/2" forged brass full-port ball valve is built for compressed-air and vacuum-pump lines. The gland-follower design keeps packing tight under repeated cycling, making it suitable for workshop and light-industrial pneumatic installations.
Behaviour under sustained pressure
Full-port construction lets air flow without the restriction of reduced-bore valves, so pressure drop stays minimal during continuous compressor runs. Forged brass body and stem resist deformation when the system stays pressurised for long shifts, and the gland follower maintains seal integrity through thermal expansion and vibration.
Replaces restricted or leaking shut-off valves
Install this valve when an existing quarter-turn ball valve shows seat wear, stem leakage or reduced flow from a narrowed bore. The upgrade is worth it if the line demands full-diameter passage for high-CFM tools or if the old valve cannot hold vacuum without weeping. Not for potable-water or gas service.
Highlights
- Full port design maximises flow capacity
- Forged brass body resists corrosion and wear
- Gland follower stem seal prevents leakage
- 1-1/2 inch connection fits standard piping
- California Proposition 65 chemical warning applies
Specifications
| Brand | LEGEND VALVE |
|---|
Questions about this item
Will the 101-067 forged brass ball valve generate noticeable heat or noise during continuous all-day operation?
As a manual forged brass full-port valve with gland follower design, it has no moving electrical parts, so it produces no operational noise or heat beyond fluid temperature.
What piping or fittings must I already have to install the 1-1/2" T-1002 valve?
You need compatible 1-1/2" pipe threads or solder-ready copper connections matching the valve ends, plus thread sealant or soldering supplies for a leak-free joint.
Can the Legend Valve 101-067 work alongside older brass or steel valves already in my compressed-air system?
Yes, the forged brass body and full-port design are compatible with existing brass, bronze or steel components in air or vacuum lines.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
