KXINXIANG
KXINXIANG Eagle E555 Diamond Control Board garage door opener
Universal control board with eight-switch feature selector for pre-2016 Eagle 100, 200, 1000 and 2000 gate operators
- TypeGarage Door Openers
- Eight-switch selector configures gate behaviour precisely
- Instant motor brake stops gate on limit switches
- One-pass tailgating feature prevents unauthorised entry
- Stop-reverse radio control enables three-button partial opening
- Compatible with Eagle 100, 200, 1000 and 2000 models
Replacement control board for Eagle gate operators
The Eagle E555 Diamond Control Board replaces the original electronics in Eagle-100, Eagle-200, Eagle-1000 and Eagle-2000 gate operators manufactured before January 2016. It is a new component intended for professional installation on existing automatic gate systems.
Eight-switch feature selector for customised
An eight-station DIP switch sets the board behaviour: master or slave mode, left or right opening, instant motor brake on limit switches, normally open or normally closed reverse loop, single-pass anti-tailgating, three-button stop-reverse transmitter control and automatic alarm reset after a five-minute shutdown.
Compatibility limited to pre-2016 Eagle models
The board fits only the four listed Eagle operator models and requires professional personnel for installation. It does not support operators made after January 2016 or any other brand of gate opener.
Highlights
- Eight-switch selector configures gate behaviour precisely
- Instant motor brake stops gate on limit switches
- One-pass tailgating feature prevents unauthorised entry
- Stop-reverse radio control enables three-button partial opening
- Compatible with Eagle 100, 200, 1000 and 2000 models
Specifications
| Type | Garage Door Openers |
|---|
Questions about this item
How do I install the Eagle E555 Diamond Control Board and which DIP-switch step is most often missed?
Fit the board into compatible Eagle-100, Eagle-200, Eagle-1000 or Eagle-2000 operators made before 2016, then set the eight-station Feature Selector; installers frequently forget Switch 2 (Gate Opening) that designates left or right hand operation.
What maintenance or replacement will the Eagle E555 board need over time?
The board itself is solid-state; plan to inspect and clean the safety-loop sensors and limit-switch contacts that feed Switch 3 (Motor Brake) and Switch 4 (Reverse Loop), and replace any worn loop wire or limit actuator rather than the board.
What is the first limit that appears when the Eagle E555 runs continuously on a busy site?
The Motor Brake (Switch 3) and Reverse Loop (Switch 4) logic relies on physical limit switches and loop detectors, so mechanical wear on those field devices — not the board — becomes the first bottleneck under sustained cycles.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
