We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Chrome-plated brass three-way quarter-turn stop valve with compression outlet

KISSLER AND CO., INC.

KISSLER AND CO., INC. 3-Way 1/4-Turn Stop 1/2 In x 3/8 In 88-9305

SKU CH-J1BZ-MXGZQ

A three-way quarter-turn supply stop with 1/2-inch FNPT inlet and 3/8-inch compression outlet, brass body, 125 psi rating, 40 to 180 Degrees F range, and IAPMO/UPC/SA listing

  • MaterialHAWA
  • Weight0.31
  • Quarter-turn operation shuts flow instantly
  • Three-way design routes water two directions
  • Chrome-plated brass resists corrosion daily
  • Brass stem rated to 125 psi pressure
  • IAPMO/UPC listed for code compliance

Quarter-Turn 3-Way Stop Valve

This quarter-turn supply stop uses a three-way body to direct flow between two outlets from a single 1/2 inch FNPT inlet. Chrome-plated brass construction handles water temperatures from 40 to 180 degrees Fahrenheit at pressures up to 125 psi. It suits residential and light commercial plumbing rough-ins where a compact diverter is required.

IAPMO UPC Listed Compliance

The valve carries IAPMO/UPC/SA listing, confirming it meets uniform plumbing code requirements for potable water systems. Inspectors accept the listing mark without additional documentation, and the chrome-plated brass stem resists dezincification in aggressive water conditions. No special tools or sealants beyond standard thread tape are needed for the compression outlet connection.

125 PSI Pressure Rating Headroom

Rated for 125 psi maximum pressure, the stop accommodates typical municipal supply pressures with margin for water hammer spikes. The 3/8 inch compression outlet fits standard fixture supply tubes, while the brass body withstands continuous hot water service up to 180 degrees Fahrenheit. Installations requiring higher pressure ratings or sweat inlet connections will need a different valve specification.

Highlights

  • Quarter-turn operation shuts flow instantly
  • Three-way design routes water two directions
  • Chrome-plated brass resists corrosion daily
  • Brass stem rated to 125 psi pressure
  • IAPMO/UPC listed for code compliance

Specifications

MaterialHAWA
Weight0.31
BrandKissler & Co

Questions about this item

Will the chrome-plated brass stem or handle need periodic lubrication or replacement over time?

The quarter-turn mechanism uses chrome-plated brass for both stem and handle, materials chosen for corrosion resistance and long service life without routine lubrication.

At 125 psi maximum pressure, will the valve body or seals become the limiting factor during continuous operation?

The brass body and chrome-plated brass stem are rated for 125 psi; sustained use at that pressure stays within the listed maximum, so neither component should reach its limit first.

How much heat does the valve transmit to the handle when water runs at 180 degrees Fahrenheit for hours?

With a temperature range up to 180 °F, the chrome-plated brass handle will become warm to the touch but remains within the material's rated operating envelope.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.