We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Four black rectangular car speakers with silver domed tweeters and textured cones

KICKER

KICKER 43DSC6804 6x8 2-Way Car Speakers 200W Peak 50W RMS 4-Ohm

SKU CH-E8HM-1W00H

Pair of 6x8 two-way car speakers delivering 50 watts RMS and 200 watts peak power with 90 dB sensitivity

  • TypeRearview Monitor
  • 200 W peak power handles loud transients without distortion
  • 50 W RMS continuous rating matches typical head-unit output
  • 45 Hz – 20 kHz frequency response covers full musical range
  • 90 dB sensitivity produces strong volume from modest amplifier power
  • 2-3/16" top-mount depth fits shallow factory speaker locations

6x8 Two-Way Speakers for Factory Replacement

These KICKER 43DSC6804 speakers fit standard 6x8 openings and handle 50 watts RMS per channel with a 10 to 50 watt recommended range. The 4-ohm impedance matches most factory and aftermarket head units without requiring an external amplifier. A polypropylene midwoofer with an acoustic-foam surround and a half-inch polyethylene-naphthalate dome tweeter cover a 45 to 20,000 Hz frequency response at 90 dB sensitivity.

Limits of a 4-Ohm Passive Design

Without a dedicated amplifier the system relies on the head unit’s built-in power, which typically delivers well below the 50 watt RMS rating. The 90 dB sensitivity helps extract volume from modest power, yet dynamic headroom stays constrained by the source. Peak power of 200 watts only applies to brief transients and does not reflect continuous output. Top-mount depth of 2-3/16 inches must clear the door cavity or rear deck.

Upgrade from Torn Paper Cones or Missing Tweeters

These speakers replace worn factory units that have lost bass authority or high-frequency detail due to foam rot or blown voice coils. The extended voice coil design improves heat dissipation during sustained playback compared to basic OEM drivers. The jump is worthwhile when the existing speakers distort at moderate volume or when the original tweeters are absent entirely. Buyers who need component-level imaging or sub-bass extension below 45 Hz will require a different architecture.

Highlights

  • 200 W peak power handles loud transients without distortion
  • 50 W RMS continuous rating matches typical head-unit output
  • 45 Hz – 20 kHz frequency response covers full musical range
  • 90 dB sensitivity produces strong volume from modest amplifier power
  • 2-3/16" top-mount depth fits shallow factory speaker locations

Specifications

TypeRearview Monitor

Questions about this item

Should I pick the 200 W peak or the 50 W RMS rating when matching my amplifier?

Match the amplifier to the 50 W RMS rating; the 200 W peak figure is a short-term maximum and not a continuous power level.

What does the 90 dB sensitivity mean once the speakers are installed in my car?

At 90 dB sensitivity, the speakers produce a strong output with modest amplifier power, so a typical head unit or small amp will drive them to loud listening levels.

How does the 4-ohm impedance affect what head units or amplifiers I can use?

The 4-ohm load is standard for car audio; most aftermarket head units and amplifiers are designed for 4 ohms, so you can connect them directly without special wiring.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.