We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black carbon-fiber pattern gooseneck phone mount with 8.3in flexible arm, 3.9in grip and 360° swivel base

Keyence

Keyence Gooseneck Car Phone Mount Carbon Fiber Pattern 8.3in Arm 3.9in Grip 360 Swivel

SKU CH-NNYM-2KENC

Flexible 8.3in gooseneck arm with 360° swivel and 3.9in grip secures phones 4.7–6.8in on dash or windshield

  • TypeCell Phone Automobile Cradles
  • Fits phones up to 6.8 inches with 3.9 inch grip
  • 3 inch arm with support keeps phone steady
  • 360 degree swivel lets you set any angle
  • Gel suction cup holds on dash or windshield
  • Works with iPhone 11 through 16 and Galaxy S20 through S25

Flexible 8.3in Gooseneck Arm

This gooseneck car phone mount uses an 8.3-inch flexible arm to position any smartphone between 4.7 and 6.8 inches wide. The expandable grips open to 3.9 inches so larger devices fit even with thick cases or card holders attached. It suits drivers who want a single mount that works across multiple phones and case styles. It is not for buyers who need a fixed short stalk or a vent-clip solution.

Dashboard 3M Pad And Gel Suction

Installation starts by sticking the included 3M VHB pad to the dashboard, then pressing the gel-coated suction cup onto that pad for a heat-resistant bond. The 360-degree swivel cradle and tilt joint are then adjusted by hand without tools. The most common issue is skipping the 3M pad, which leaves the suction cup on textured plastic and causes the mount to detach in hot weather.

Check Dashboard Surface And Clearance

Before ordering, verify the dashboard has a smooth flat area at least as wide as the suction base so the 3M pad can adhere properly. Confirm there is enough sweep radius for the 8.3-inch arm to reach your line of sight without blocking vents or the instrument cluster. The mount will not work on heavily textured dashboards or deeply curved windshields where the pad cannot seal.

Highlights

  • Fits phones up to 6.8 inches with 3.9 inch grip
  • 3 inch arm with support keeps phone steady
  • 360 degree swivel lets you set any angle
  • Gel suction cup holds on dash or windshield
  • Works with iPhone 11 through 16 and Galaxy S20 through S25

Specifications

TypeCell Phone Automobile Cradles

Questions about this item

How do I verify the mount stays stable once the 8.3in arm and dash support are positioned?

After attaching the gel-coated suction cup to the windshield and the 3M VHB pad to the dashboard, press the phone into the rubber-coated grips and drive over a rough patch; the arm should not bounce or slip.

Which accessories are included and what must I purchase separately?

The package includes the gooseneck arm, suction cup, 3M VHB dashboard pad, and cradle with expandable grips; no extra parts are required for installation.

Will the 3.9in grip fit my phone if it measures between 4.7 and 6.8 inches?

Yes, the expandable grips extend to 3.9 inches and are designed for devices from 4.7 to 6.8 inches, including larger models with thick cases or ring holders.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.