Keson Industries
Keson Industries PG1825ALV 25 ft tape measure 1 in blade
A 25 ft steel tape with autolock and push-button rewind, 1 in blade marked in 1/16 in and 1/32 in for the first 12 in, housed in a high-visibility orange ABS case with rubber grip
- Length6.400
- Width4.600
- TypeLong
- Autolock holds the blade steady during layout
- Push-button release rewinds the tape with one hand
- 25 ft reach covers long runs without repositioning
- 1 in wide steel blade resists bending across spans
- High-visibility orange ABS case with rubber grip stays easy to find and hold
Keson PG1825ALV 25 ft Tape Measure
This Keson tape measure has a 25 ft steel blade that is 1 in wide. An autolock mechanism holds the blade in place until the push-button release is pressed for automatic rewind. The high-visibility orange ABS case includes a rubber grip and measures 4 in in length.
Users who need SAE graduations down to 1/32
Graduation marks are 1/16 in along the full blade with finer 1/32 in marks only on the first 12 in. The non-magnetic single hook suits general layout work but will not hold to ferrous surfaces. Builders who require magnetic tip retention or metric graduations should look at something else.
Autolock and push-button release change daily use
The automatic lock removes the need to slide a thumb lock while marking. A single press of the release button rewinds the blade without manual guidance. The rubber grip on the ABS case improves handling when hands are wet or gloved.
Highlights
- Autolock holds the blade steady during layout
- Push-button release rewinds the tape with one hand
- 25 ft reach covers long runs without repositioning
- 1 in wide steel blade resists bending across spans
- High-visibility orange ABS case with rubber grip stays easy to find and hold
Specifications
| Brand | Keson |
|---|---|
| Length | 6.400 |
| Width | 4.600 |
| Type | Long |
Questions about this item
Does the 1 in blade width fit my existing belt clip?
The blade is 1 in wide and the case is 4 in long, so a clip sized for a 1 in blade and a 4 in case will hold it securely.
Can I read the 1/32 in marks on the first 12 in alongside my older 1/16 in tape?
The first 12 in show 1/32 in graduations while the rest use 1/16 in, so you can switch between the finer and coarser scales on the same blade.
How do I confirm the autolock engages when I extend the 25 ft blade?
Pull the blade out; the autolock should hold it at any length without sliding, and pressing the push-button release rewinds it automatically.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
