Keson Industries
Keson Industries Engineers Long Tape Measure 1/2 in x 100 ft Orange
A 100 ft fiberglass engineers tape with 1/10 and 1/100 ft graduations, double PVC coating, a two-rivet hook, rubber grip and manual speed rewind in an orange ABS open case
- Length11.500
- Width8.300
- MaterialHAWA
- TypeEngineers
- 100 ft blade reaches long runs
- Fiberglass tape resists stretch and moisture
- Double PVC coating protects graduations
- Metal gearing speeds manual rewind
- Rubber grip improves handling in wet conditions
Engineers tape for long runs
This 100 ft engineers tape measure is built for surveyors and civil crews who lay out site grids, road alignments and utility trenches. The fiberglass blade resists stretch and moisture, so measurements stay consistent across repeated pulls in mud or dust. The orange ABS case is easy to spot on a busy job site.
100 ft blade with 1/10 and 1/100 ft graduations
The blade reaches 100 ft and is marked in tenths and hundredths of a foot, matching engineering plans directly without conversion. Double PVC coating protects the white blade face from abrasion on gravel or concrete. Manual rewind with metal gearing returns the tape smoothly, but there is no lock so the blade retracts freely when released.
Two-rivet hook and rubber grip
The 2-rivet hook anchors securely on stakes, rebar or pipe ends, reducing slip during solo measurements. A rubber grip on the case improves hold when hands are wet or gloved. No belt clip is fitted, so the tape rides in a tool bag or bucket rather than on a waistband.
Highlights
- 100 ft blade reaches long runs
- Fiberglass tape resists stretch and moisture
- Double PVC coating protects graduations
- Metal gearing speeds manual rewind
- Rubber grip improves handling in wet conditions
Specifications
| Brand | Keson |
|---|---|
| Length | 11.500 |
| Width | 8.300 |
| Material | HAWA |
| Type | Engineers |
Questions about this item
Will the 1/2 in fiberglass blade fit the same reel brackets I use on my older steel tapes?
The open ABS case has no belt clip and uses manual rewind, so it mounts differently from spring-loaded steel models; check your bracket spacing before installing.
How do I confirm the 1/10 and 1/100 ft graduations are accurate after unboxing?
Extend the white blade fully, lock the manual rewind, and compare the 10 ft and 100 ft marks against a calibrated rule; the double PVC coating should not stretch.
Does the box include the 2-rivet hook and rubber grip, or must I order them separately?
The 2-rivet hook and rubber grip are factory-fitted to the blade and case; nothing extra is required for basic measuring tasks.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
