Kerr Lakeside
Kerr Lakeside Socket Cap Screw 3/4-10x2 1/2 Pk25
Alloy-steel flat-head socket cap screws, 3/4-10 UNC thread, 2 1/2 inch length, black-oxide finish, pack of 25
- High tensile strength for demanding loads
- Black oxide finish resists corrosion
- Fully threaded design ensures full engagement
- Hex socket drive allows high torque
- Pack of 25 covers multiple jobs
Socket Cap Screw 3/4-10x2 1/2
Kerr Lakeside supplies these alloy steel flat head cap screws in a pack of 25. The UNC 3A right-hand thread runs the full 2 1/2 inch length under the head. A 1/2 inch hex socket drive fits standard bits for installation in structural or machine assemblies.
Sustained Load Performance
Minimum tensile strength is rated at 135,000 psi for diameters over 1/2 inch. Rockwell hardness falls between RC 38 and 43. The black oxide finish adds mild corrosion resistance while the Class 3A thread tolerance maintains clamping force under continuous vibration.
Compatibility Check
Verify that the mating thread is 3/4-10 UNC and that the 1.438 inch head diameter clears the counterbore. Confirm the 0.396 inch head height suits the available stack height. Ensure the 1/2 inch hex drive can be accessed with the tool clearance on site.
Highlights
- High tensile strength for demanding loads
- Black oxide finish resists corrosion
- Fully threaded design ensures full engagement
- Hex socket drive allows high torque
- Pack of 25 covers multiple jobs
Specifications
| Brand | Kerr Lakeside |
|---|
Questions about this item
Does the 3/4-10 UNC thread generate noticeable vibration or heat during extended pneumatic tool use?
These alloy-steel socket cap screws are fully threaded fasteners with a Rockwell hardness of RC 38-43 and a minimum tensile strength of 180,000 PSI; they do not produce vibration or heat themselves.
What drive tool is required to install the 1/2-inch hex socket drive on these screws?
A 1/2-inch hex key or compatible hex bit is needed to engage the internal hex socket drive on each screw.
Will the 1.438-inch head diameter and 0.396-inch head height clear countersunk holes in older ASTM A574-rated fixtures?
The flat head measures 1.438 inches in diameter and 0.396 inches in height, meeting ASTM A574 and ANSI B18.3 Class 3A dimensions for direct replacement in existing countersunk holes.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
