KEHIPI
KEHIPI UR-US-HL9OR5 Electrician Tool 5pcs 15A 1500V 6.56ft .39in
Five dual-ended alligator clip leads with copper jaws, 15 A and 1500 V rating, 6.56 ft silicone-insulated wire and .39 in maximum jaw opening
- 15 A / 1500 V rating supports moderate-power testing
- 39 in jaw opening grips a range of component leads
- 56 ft silicone-insulated cable reaches remote test points
- Five colour-coded leads simplify circuit identification
- Copper alligator clips with insulator boots reduce accidental shorts
Five-piece test lead set
The KEHIPI UR-US-HL9OR5 supplies five dual-ended alligator-to-alligator clip leads for electrical testing. Each lead uses soft silicone insulation over copper clips rated at 1500V and 15A. The clips open to a maximum width of .39in for secure attachment. The total wire length measures 74.6in per lead, providing generous reach for remote test points.
Suited for bench and vehicle work
Hobbyists, students and technicians assembling temporary circuits or probing automotive accessories will find the colour-coded leads convenient. The insulated boots reduce accidental shorts during hands-free measurements. Builders who need higher current capacity, specialised probe tips or shielded cables for sensitive signal work should look elsewhere.
Capacity and headroom
The 15A rating comfortably handles fused automotive accessory circuits and typical bench power supplies. The 1500V rating covers most low-voltage laboratory and vehicle systems. Leads will run out of headroom on unfused high-current starter circuits or any application exceeding the stated 15A continuous limit.
Highlights
- 15 A / 1500 V rating supports moderate-power testing
- 39 in jaw opening grips a range of component leads
- 56 ft silicone-insulated cable reaches remote test points
- Five colour-coded leads simplify circuit identification
- Copper alligator clips with insulator boots reduce accidental shorts
Specifications
| Brand | Sumnacon |
|---|---|
| Model | UR-US-HL9OR5 |
Questions about this item
What wire length do I need on my bench so the 6.56 ft leads reach both test points?
Each lead is 6.56 ft (74.6 in) long, so measure the distance between your two furthest test points and ensure it is less than that length.
Will the .39 in jaw opening grip the screw terminals on my vintage motorcycle wiring harness?
The clips open to .39 in (1 cm), which fits most vintage motorcycle screw terminals and small-gauge wires.
How can I confirm the 15 A rating is holding during a load test?
Place a calibrated ammeter in series with the clip leads; the reading should stay at or below 15 A while the circuit is energised.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
