K Tool International
K-Tool International KTI-35154 1" Drive 1-11/16" SAE Socket 6 Points
Impact socket with 1-inch drive and 1-11/16-inch SAE size, six-point design for high-torque applications
- 1" drive fits large impact wrenches
- 1-11/16" SAE size for heavy fasteners
- 6-point design grips flats not corners
- Short length improves access in tight spots
- Impact-rated steel withstands high torque loads
Professional impact socket for heavy-duty fastening
The K-Tool International KTI-35154 is a 1 inch drive SAE impact socket sized at 1-11/16 inches with a six-point profile. It is built for technicians and maintenance crews who work on large commercial, agricultural or industrial equipment where high torque is routine. The short length keeps the tool compact in tight engine bays or chassis areas.
No moving parts means silent operation
As a solid steel hand tool it produces no noise, generates no heat and consumes no electricity or compressed air by itself. Thermal behaviour is limited to normal expansion from ambient temperature or from the impact wrench driving it. There are no fans, pumps or electronics to fail or to add acoustic load in the workshop.
Six-point geometry grips flats under sustained
The six-point opening distributes force across the fastener flats rather than the corners, reducing rounding during repeated high-torque cycles. Heat from extended impact-wrench use dissipates through the socket mass without affecting hardness or dimensional stability. The tool remains reliable for continuous heavy-duty service without performance loss.
Highlights
- 1" drive fits large impact wrenches
- 1-11/16" SAE size for heavy fasteners
- 6-point design grips flats not corners
- Short length improves access in tight spots
- Impact-rated steel withstands high torque loads
Specifications
| Brand | K-TOOL INTERNATIONAL |
|---|
Questions about this item
How do I install the KTI-35154 onto a 1" drive impact wrench, and what step is often missed?
Slide the 1-11/16" 6-point socket squarely onto the 1" square drive until it seats fully; the step often missed is verifying the detent ball locks into the drive groove before applying torque.
What maintenance or replacement will the KTI-35154 need after repeated impact use?
Inspect the 6-point walls and square drive for rounding or cracks; replace the socket if the 1-11/16" hex profile shows deformation or the drive end wears loose.
What limit appears first on the KTI-35154 under sustained heavy impact work?
The 6-point opening can round off on stubborn fasteners before the 1" drive end fails, especially when high torque is applied continuously.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
