JB Industries
JB Industries CLS-72R HVAC control 72 in 45 deg 800 psi red
High-side hose with 45-degree fitting, 72-inch length and 800 psi working pressure for refrigerant manifold gauge sets
- ColorRed
- 72-inch reach lets you service distant ports without strain
- 45-degree angled fitting clears tight engine-bay obstacles
- 800 psi working pressure handles high-side refrigerant loads safely
- Kevlar-reinforced rubber hose resists abrasion and chemical wear
- Brass fittings provide leak-free sealing on manifold gauge sets
High-side hose for manifold gauge sets
The JB Industries CLS-72R is a single red high-side hose built for refrigerant manifold gauge sets. It uses a 45-degree brass fitting with a 1/4-inch female connection and a rubber and Kevlar-reinforced hose body. The 72-inch length gives reach across engine bays or service bays. It is intended for technicians who need a dedicated high-side line.
Sustained pressure performance
The hose is rated for a working pressure of 800 psi and a burst pressure of 4,000 psi, so it holds up during long recovery or charging sessions without ballooning. The Kevlar reinforcement resists expansion under continuous load better than standard rubber alone. The brass fitting maintains a seal through repeated thermal cycles. It is not suited for applications that exceed the stated working pressure.
Straightforward connection, watch the angle
The 45-degree brass fitting threads onto the manifold gauge port with standard hand tools and the 1/4-inch female end accepts common couplers. The fixed angle can interfere with tight clearances around some service ports, so verify routing space before installing. Over-tightening the brass nut risks damaging the threads. No additional seals or adapters are included.
Highlights
- 72-inch reach lets you service distant ports without strain
- 45-degree angled fitting clears tight engine-bay obstacles
- 800 psi working pressure handles high-side refrigerant loads safely
- Kevlar-reinforced rubber hose resists abrasion and chemical wear
- Brass fittings provide leak-free sealing on manifold gauge sets
Specifications
| Brand | JB INDUSTRIES |
|---|---|
| Color | Red |
Questions about this item
How does the 800 psi working pressure affect heat and stress during all-day HVAC jobs?
The hose is rated for 800 psi working pressure with a 4000 psi burst rating, so it handles sustained high-side pressure without overheating or softening during extended use.
What manifold gauge set fitting is required to connect this 1/4 in female 45-degree hose?
You need a manifold gauge set with a matching 1/4 in male flare fitting to thread onto the hose’s 45-degree female end.
Will the 72 in length and 45-degree angle reach the service ports on the older manifold sets I already use?
The 72-inch length and 45-degree brass fitting are designed for standard 1/4 in flare connections found on most refrigerant manifold gauge sets.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
