We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Pair of tan leather driver gloves with shirred cuffs and wing thumbs

Ironclad

Ironclad ULD-C5-05-XL Cut Resistant Gloves A5 Uncoated XL Pair

SKU CH-YMKD-3ZYWV

Full-leather drivers gloves with Kevlar stitching and HPPE liner deliver ANSI A5 cut resistance and Level 2 heat protection up to 284 °F

  • ANSI A5 cut resistance protects against severe laceration hazards
  • Kevlar stitching reinforces seams for longer glove life
  • Heat level 2 rated to 284°F for hot-surface contact
  • Full leather coverage shields palm, fingers and back of hand
  • HPPE liner adds cut protection without sacrificing dexterity

Cut-Resistant Gloves A5 Uncoated

These Ironclad gloves provide ANSI/ISEA Cut Level A5 protection across the full hand with a full-leather drivers style. They are built for workers who need high cut resistance without a coated palm, offering a bare-hand feel for material handling, fabrication and general industrial tasks. Sold as a left-and-right pair in size XL.

Capacity and Headroom

The A5 rating delivers strong resistance to sharp edges and blades encountered in metalworking, glass handling and assembly work. Heat protection reaches ANSI/ISEA Heat Level 2, rated to a maximum temperature of 284 degrees F for brief contact. The uncoated leather surface preserves tactile sensitivity but offers no liquid barrier or additional hazard protection beyond cut and heat.

Kevlar Stitching and Slip-On Cuff

Seams are stitched with Kevlar thread for durability under stress, while the shirred slip-on cuff allows quick donning and doffing without straps. The wing-thumb design follows the natural hand contour for comfort during extended wear. An HPPE liner adds cut-resistant reinforcement beneath the leather, and the 10 1/32 inch length covers the wrist without restricting forearm movement.

Highlights

  • ANSI A5 cut resistance protects against severe laceration hazards
  • Kevlar stitching reinforces seams for longer glove life
  • Heat level 2 rated to 284°F for hot-surface contact
  • Full leather coverage shields palm, fingers and back of hand
  • HPPE liner adds cut protection without sacrificing dexterity

Specifications

BrandIRONCLAD PERFORMANCE WEAR

Questions about this item

Will the A5 cut level and full leather coverage hold up when I am handling sharp sheet metal with my older leather palm gloves?

The ANSI/ISEA A5 rating and full leather coverage give you high cut resistance across the entire hand, so they can replace older palm-only gloves for sheet-metal work.

How can I verify the Kevlar stitching and HPPE liner are performing after I start using them?

Inspect the seams for intact yellow Kevlar thread and check that the HPPE liner shows no pulled fibres or thinning after a shift; both indicate the A5 protection is still active.

Does the pair include any coating or insulation, or do I need to buy a separate liner for cold environments?

The gloves are sold as an uncoated, non-insulated pair with a shirred slip-on cuff, so a separate thermal liner would be needed for cold conditions.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.