We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Pair of grey knit gloves with black nitrile coating on palms and fingers

Ironclad

Ironclad SKC5SN-01-XS Cut-Resistant Coated Gloves, Cut Level A5

SKU CH-KE7C-GPTAZ

Cut-resistant knit gloves rated ANSI/ISEA A5 with double-dipped nitrile coating and reinforced thumb crotch

  • ANSI/ISEA Cut Level A5 protection for high-risk tasks
  • HPPE knit shell delivers cut resistance with dexterity
  • Double-dipped nitrile coating covers 3/4 of glove for grip and abrasion defence
  • Reinforced thumb crotch extends wear life in high-stress areas
  • ANSI/ISEA Needlestick Level 1 on palm adds puncture resistance

Ironclad SKC5SN-01-XS Cut-Resistant Gloves

These gloves provide ANSI/ISEA Cut Level A5 protection for hands exposed to sharp edges and materials. They suit workers in manufacturing, assembly, automotive maintenance and general industrial tasks where laceration risk is high. The HPPE knit shell delivers cut resistance while maintaining dexterity for detailed work. Buyers needing needlestick protection beyond Palm Level 1 or chemical permeation resistance should select a different model.

Double-Dipped Nitrile Coating

The 3/4 double-dipped nitrile coating extends grip coverage across the palm and fingers while leaving the back of the hand breathable. A reinforced thumb crotch adds durability at a high-wear point, reducing premature failure during repetitive gripping. The coating enhances wet and oily grip without sacrificing tactile sensitivity. Users requiring full hand immersion or palm-only coating will find this coverage pattern unsuitable.

Verify ANSI Cut Level A5 Matches Your Hazard

Confirm that your safety officer or risk assessment specifies ANSI/ISEA Cut Level A5 for the intended application. The gloves carry no abrasion rating and offer Palm Needlestick Level 1 only, so they do not address puncture or abrasion hazards beyond that level. Sizing runs by letter designation; measure hand circumference against the manufacturer chart before ordering. Workers with latex allergies can use these nitrile-coated gloves without concern.

Highlights

  • ANSI/ISEA Cut Level A5 protection for high-risk tasks
  • HPPE knit shell delivers cut resistance with dexterity
  • Double-dipped nitrile coating covers 3/4 of glove for grip and abrasion defence
  • Reinforced thumb crotch extends wear life in high-stress areas
  • ANSI/ISEA Needlestick Level 1 on palm adds puncture resistance

Specifications

BrandIRONCLAD

Questions about this item

How often should I replace the nitrile coating once it starts wearing through?

Replace the gloves when the 3/4 double-dipped nitrile coating shows visible wear or the reinforced thumb crotch no longer protects against cuts.

Will the HPPE knit maintain its A5 cut rating after repeated abrasion cycles?

The ANSI/ISEA abrasion level is not rated, so sustained friction may degrade the HPPE fibres before the A5 cut resistance is compromised.

Do the gloves become hot or cause hand fatigue during all-day wear?

The 3/4 nitrile coating limits breathability; expect warmer hands and possible moisture build-up during continuous use.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.