We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in

Intermec

Intermec 1-040082-900 PX4i printhead 203 dpi thermal

SKU CH-0PGB-J6ZQT

Replacement 203 dpi thermal printhead for the PX4i printer

  • 203 dpi resolution delivers sharp barcode and text output
  • Thermal printing requires no ink or ribbon supplies
  • Designed specifically for the PX4i printer model
  • Genuine Intermec part number 1-040082-900 ensures compatibility

Intermec PX4i 203 dpi thermal printhead

This is a genuine Intermec thermal printhead rated at 203 dots per inch for the PX4i printer. It is supplied new and ready for installation. The part replaces the original printhead when print quality degrades or the unit fails. It is not suitable for printers that require a different resolution or a non-thermal printing method.

Thermals noise and power draw in normal use

The printhead generates heat only during the thermal transfer process used to create each label. Power consumption is limited to the printer's normal operating current for the 203 dpi element array. No moving parts or fans are present, so the component itself adds no audible noise beyond the printer mechanism.

Highlights

  • 203 dpi resolution delivers sharp barcode and text output
  • Thermal printing requires no ink or ribbon supplies
  • Designed specifically for the PX4i printer model
  • Genuine Intermec part number 1-040082-900 ensures compatibility

Specifications

No published specifications for this item yet.

Questions about this item

How do I install the 1-040082-900 printhead in the PX4i without damaging the 203 dpi thermal element?

Power off the printer, open the printhead latch, slide the old unit out, insert the new printhead until it seats fully, close the latch firmly, then run a calibration print to verify alignment.

When should I replace the 203 dpi thermal printhead on my PX4i to maintain print quality?

Replace the printhead when output shows consistent voids, streaks, or faded areas that cleaning cannot fix, typically after several million linear inches of thermal printing.

More in Printer & Scanner Supplies

Similar items

Same shelf, same checkout — eight coins and a 30-minute rate lock.